Cisco 2821 - Integrated Services Router Unified Communications Bundle Schnellstart-Handbuch - Seite 20
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Netzwerk-Router Cisco 2821 - Integrated Services Router Unified Communications Bundle herunter. Cisco 2821 - Integrated Services Router Unified Communications Bundle 47 Seiten. Overview
Auch für Cisco 2821 - Integrated Services Router Unified Communications Bundle: Konfiguration (10 seiten), Übersicht (27 seiten)
Seite drucken
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety, connect the
Caution
built in Gigabit Ethernet ports only to intra-building or unexposed wiring or cable. The intrabuilding cable must
be shielded and the shield must be grounded at both ends. The intra-building port(s) of the equipment or
subassembly must not be metallically connected to interfaces that connect to the OSP or its wiring. These interfaces
are designed for use as intra-building interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE, Issue
4) and require isolation from the exposed OSP cabling. The addition of Primary Protectors is not sufficient
protection in order to connect these interfaces metallically to OSP wiring.
Power Connections
This section describes procedures for connecting your router to AC power, DC power, and backup power. See the appropriate
subsection:
• Connecting the Router to AC Power, page 20
• Connecting the Router to DC Power, page 21
• Connecting the Router to Backup Power, page 26
Cisco 2801 routers are not designed to connect to DC power.
Note
Warning
Read the installation instructions before connecting the system to the power source. Statement 1004
The installation must comply with all required electrical codes applicable at the installation site.
Note
Connecting the Router to AC Power
If your router uses AC power, connect it to a 15 A, 120 VAC (10 A, 240 VAC) circuit with overcurrent protection. If backup
power is required, see the "Connecting the Router to Backup Power" section on page 26.
Note
The input voltage tolerance limits for AC power are 85 and 264 VAC.
Warning
AC connected units must have a permanent ground connection in addition to the power cable ground wire.
NEBS-compliant grounding satisfies this requirement. Statement 284
Warning
This product requires short-circuit (overcurrent) protection, to be provided as part of the building installation.
Install only in accordance with national and local wiring regulations. Statement 1045
Warning
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than:
120 VAC, 15 A (240 VAC, 10 A). Statement 1005
20