Cisco 7100 Series Schnellstart-Handbuch - Seite 16
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Netzwerk-Router Cisco 7100 Series herunter. Cisco 7100 Series 25 Seiten. Field-replaceable units in vpn routers
Auch für Cisco 7100 Series: Handbuch zur Installation (21 seiten)
Seite drucken
Connect the Power (continued)
5
I
E3
TX
EN
RX
CEL CAR ALM
14
Connect the Cisco 7140 Series Dual AC Power Supply
The power supply is a four-output switching power supply with power factor correction and
regulated outputs.
Note: For additional AC power cable strain relief, secure the cable to the power supply handle
by inserting a nylon cable tie through the hole in the handle and around the cable.
1
At the rear of the router, check that the power switch is in the off (O) position.
2
Slide the cable-retention clip up, away from the AC receptacle, and plug in the power cable.
3
Secure the cable in the power supply AC receptacle by sliding the cable-retention clip down
until it fits around the connector. The cable-retention clip provides strain relief for the AC
power cable.
4
Plug the AC power supply cable into the AC power source.
Note: For full redundancy, plug the second AC power cord into a separate power source.
SLOT 0
SLOT 1
ACT
ACT
LNK
LNK
RX
FE 0 / 0
FE
0 / 1
0
1
E3
TX
RX
EN
RX
CEL CAR ALM
AC power cable
AC OK
DC OK
OTF
PWR
0
SYS
AC OK
CONS
AUX
RDY
DC OK
OTF
2
7140 - 2AE3
100-24 0Vac 50/60H z
5-2.5A 525W
Cable-retention clip