Cisco 7100 Series Handbuch zur Installation - Seite 10
Blättern Sie online oder laden Sie pdf Handbuch zur Installation für Netzwerk-Router Cisco 7100 Series herunter. Cisco 7100 Series 21 Seiten. Field-replaceable units in vpn routers
Auch für Cisco 7100 Series: Schnellstart-Handbuch (25 seiten)
Seite drucken
Removing the Router from the Rack
Figure 6
Note: The second bracket attaches to the other side of the chassis.
Step 4
Step 5
Step 6
Removing the Router from the Rack
This section describes how to remove the router from the rack. To gain access to the SDRAM
DIMMs, you must power off the router and remove it from the rack.
To remove the router from the rack:
Step 1
Step 2
Step 3
Step 4
10 Installing Field-Replaceable Units in Cisco 7100 Series VPN Routers
Attaching the Chassis to the 19-Inch Rack—Rear Panel Forward
0
2
The brackets can also be installed with the front panel forward.
To complete the next three installation steps, refer to Chapter 3, "Installing
Note
Cisco 7100 Series Routers" in the Cisco 7100 Series VPN Router Installation and
Configuration Guide.
Attach the grounding lug to the chassis.
Connect the interface cables.
Connect the AC power cord and power on the router.
Shut down all interfaces. Power off the router and disconnect site power.
The power switch is part of the power supply.
Note
Remove all interface cables from the rear panel of the router. Ensure that the cables are
adequately marked to assist you when you reconnect the cables.
Remove the screws that secure the router to the rack. Do one side at a time. Have a second
person hold the router while you remove the screws.
Place the router so that the front panel is facing you. If you place the router on a table,
ensure that you have clear access to all sides.