Cisco Nexus 9000 Series Installationshandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Installationshandbuch für Netzwerk-Router Cisco Nexus 9000 Series herunter. Cisco Nexus 9000 Series 12 Seiten. Switch chassis
Auch für Cisco Nexus 9000 Series: Schnellstart-Konfigurationshandbuch (6 seiten), Konfigurationshandbuch (32 seiten), Konfigurationshandbuch (32 seiten), Handbuch (30 seiten), Installation von (8 seiten), Schnellstart-Handbuch (14 seiten), Handbuch (16 seiten)

Installing the Switch Chassis

Note

You can align any four of the holes in the front rack-mount bracket to four of the six screw holes on the side

of the chassis (see the following figure). The holes that you use depend on the requirements of your rack

and the amount of clearance required for interface cables (3 inches [7.6 mm] minimum) and module handles

(1 inch [2.5 mm] minimum).

Figure 1: Two Ways to Attach Rack-Mount Brackets and Guides on the Switch

Front rack-mount bracket aligned to the module end

of the chassis

Four M4 screws used to attach the bracket to the

chassis

Rear rack-mount guide aligned to the port connection

end of the chassis

Two M4 screws used to attach the bracket to the

chassis

c) Secure the front-mount bracket to the chassis using four M4 screws and tighten each screw to 12 in-lb (1.36 N·m)

of torque.

d) Repeat Step 1 for the other front rack-mount bracket on the other side of the switch and be sure to position that bracket

the same distance from the front of the switch.

Step 2

Install the two rear rack-mount brackets on the chassis as follows:

a) Align the two screw holes on a rear rack-mount bracket to the middle two screw holes in the remaining six screw

holes on a side of the chassis. If you are aligning the guide to holes that are near the port connections end of the

chassis, see Callout 3 in the previous figure. Otherwise, see Callout 7 in the previous figure.

Front rack-mount bracket aligned to the port

connections end of the chassis

Four M4 screws used to attach the bracket to the

chassis

Rear rack-mount guide aligned to the mobile end of

the chassis

Two M4 screws used to attach the bracket to the

chassis

Cisco Nexus 9372TX ACI-Mode Switch Hardware Installation Guide

Installing the Switch