CAB 5540750 Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Drucker-Zubehör CAB 5540750 herunter. CAB 5540750 14 Seiten. External rewinder

Start-Up

3.3

Connecting to Power Supply

The rewinder is equipped with a wide range power unit (100-240V~), so it is possible to use the printer both with a

voltage of 230V~/50 Hz and with a voltage of 115V~/60 Hz without making changes to the printer.

Warning!

Risk of injury by rotating engine parts.

Make sure the power switch (1) is in position „O" (OFF) before connecting the printer to a power supply !

When switching on the Rewinder starts immediately without or with loose material

Figure 3

Power supply

The rewinder is ready for use, if the power cable (3) supplied in the accessories is inserted into a power supply

connector (2) and the cable is contacted to a grounded outlet.

4.1

The print an dispense of the label are orientated to the center at the MACH4 printer.

The position of the rewinded labels at the external rewinder are orientated to the plate (2) side of the rewind axle.

So it's essential to adjust the external rewinder to the printer depend of label material broadness.

Figure 4

Sighting the external rewinder to the printer

label material

width

1. Separate the external rewinder (1) from connecting set.

2. Loosen knurled nut (4) .

3. Move connecting plate (3) up to the arrow are opposite the

value (in mm) of the material broadness .

4. Tighten knurled screw (4) .

5. Put the external rewinder (1) on the connecting set

( 3.2 Mount the connecting set).

6. Put in label material.