CAB 6114 Series Montageanleitung Handbuch - Seite 14

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Drucker-Zubehör CAB 6114 Series herunter. CAB 6114 Series 19 Seiten. Air-jet box

External Start-Sensor

5.1

The start signal to apply the label can originate from an external sensor connected to the 3 pole connector (1)

connected directly to the applicator.

Fig. 10

Start signal connector on the applicator

Fig. 11

Examples of connections of start sensors

The start of the printing job - print first label is still initiated over the I/O interface of the printer. Circuitry and

programming of the connections is to be set as illustrated.

5.2

•

The signal FSTLBL respectively DREE

waiting position.

•

The signal START will transport and apply the label to the product.

In the application mode "Apply - Print" the printing of the next label starts directly after application of the previous label.

In the application mode "Print - Apply" the signal START must be sent for the print.

Signal Name

FSTLBL

DREE

START

 Interface description of the printer

Table3

without applicator

(Hermes+)

Print start signal

Precondition: The superior control

has confirmed with the ETE signal

that the previous label has been

taken from the peel-off position.

A section of the interface description of the label printer

causes the label to be printed which is then transported to the

(Hermes+)

Description

with applicator

Cycle sequence = Apply-Print

Print first label

Start of printing and

labeling

Activation/active status

Switch on +24V between

Pin 1 and Pin 25

+24V between Pin 13 and Pin