CABAC BM118 Benutzerhandbuch - Seite 11

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Multimeter CABAC BM118 herunter. CABAC BM118 14 Seiten. Auto-check clamp-on series

is resistive or shorted (defective).

●Press SELECT button momentarily AGAIN selects Capacitance function.

Capacitance measurement time varies with capacitance value. Only a few seconds is

required for measuring values of below 100µF. However, one minute or more is

required for measuring extreme values of around 2000µF.

HOLD

feature

The Hold feature freezes the display for later viewing. Press the HOLD

momentarily to toggle to the Hold feature. The annunciator " " turns on.

Backlighted display (model 118 only)

Press the SELECT button for 1 second or more to turn on or off the display backlight

feature.

Auto Power Off (APO)

The meter turns off intelligently after approximately 3 minutes of neither significant

measurement nor button/switch activity. To wake up the meter from APO, press any

button or turn the rotary selector to OFF and back on again. Always turn the rotary

selector to OFF when the meter is not in use.

5) MAINTENANCE

WARNING

To avoid electrical shock, disconnect the meter from any circuit, remove the test leads

from the input jacks and turn OFF the meter before opening the case. Do not operate

with open case.

Trouble Shooting

If the instrument fails to operate, check batteries and test leads etc., and replace as

necessary. Double check operating procedure as described in this user's manual

If the instrument voltage-resistance input terminal has subjected to high voltage

transient (caused by lightning or switching surge to the system) by accident or

abnormal conditions of operation, the series fusible resistors will be blown off (become

high impedance) like fuses to protect the user and the instrument. Most measuring

functions through this terminal will then be open circuit. The series fusible resistors and

the spark gaps should then be replaced by qualified technician. Refer to the LIMITED

WARRANTY section for obtaining warranty or repairing service.

Customer Care Australia P: 13122 F: 1300 303 310 E: [email protected] W:cabac.com.au

A: Distribution Pl, Seven Hills NSW 2147

Customer Care New Zealand P: 0800 966 969 F: 0088 6969 E: [email protected] W: cabac.co.nz

button