Epson V11H158020 - PowerLite 61p SVGA LCD Projector Informationen zum Produkt - Seite 13

Blättern Sie online oder laden Sie pdf Informationen zum Produkt für Projektor Epson V11H158020 - PowerLite 61p SVGA LCD Projector herunter. Epson V11H158020 - PowerLite 61p SVGA LCD Projector 15 Seiten. Product support bulletin(s)
Auch für Epson V11H158020 - PowerLite 61p SVGA LCD Projector: Benutzerhandbuch (42 seiten), Spezifikationen (2 seiten), Betriebshandbuch (47 seiten), Installationshandbuch (19 seiten), Produkt-Support-Bulletin (8 seiten)

Seite drucken
Epson V11H158020 - PowerLite 61p SVGA LCD Projector Informationen zum Produkt
5. Use the screwdriver to loosen the two screws holding the
lamp in place. (You can't remove the screws.)
6. Hold the lamp as shown and pull it straight out.
Warning:
This product includes a lamp component that contains mercury
(Hg). Please consult your state and local regulations regarding
disposal or recycling. Do not put it in the trash.
7. Gently insert the new lamp. If it doesn't fit easily, make sure
it's facing the correct way.
8. Once the lamp is fully inserted, tighten its screws.
Caution:
Do not touch the glass portion of the lamp assembly. Touching
the glass could result in premature lamp failure.
Don't remove
these screws
Epson PowerLite 61p/81p Projector
9. Lower the lamp cover into place. (The opening should be
almost covered, and the top of the lamp cover should be
flush with the surface of the projector.) Then slide the cover
closed and tighten the screw.
10.Reset the lamp timer as described in the next section.

Resetting the Lamp Timer

You must reset the lamp timer after replacing the lamp to clear
the
Replace the Lamp
Note:
Do not reset the lamp timer if you have not replaced the lamp. If
you do, the
Lamp Hours
hours that the lamp has been used.
1. Connect the power cable and turn on the projector.
2. Press the
button on the remote control and select the
Menu
menu. Then press
Reset
3. Select
Lamp-Hours Reset
following:
6/04
Epson PowerLite 61p/81p Projector
message.
will not accurately reflect the number of
. You see the following:
Enter
and press Enter. You see the
13
-