Argent C10SW0806 Einbauanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Einbauanleitung für Inneneinrichtung Argent C10SW0806 herunter. Argent C10SW0806 2 Seiten. Wall hung

Seite drucken
I N S P E C T T H E F U R N I T U R E
TO ENSURE NO DAMAGE HAS
OCCURRED DURING TRANSIT. IF
DAMAGE HAS OCCURRED, OR
VISIBLE DEFECTS EXIST, DO NOT
PROCEED WITH INSTALLATION AND
3
ADVISE ARGENT IMMEDIATELY.
FURNITURE MUST BE FITTED
THROUGH STUDS INTO THE
WALL. USE FIXING BRACKETS
PROVIDED.
5
IF STUD POSITIONING DOES NOT
850mm
ALIGN WITH FIXING BRACKETS,
CABINET MUST BE ADDITIONALLY
SECURED THROUGH THE BACK
2
BOARD TO STUDS. IF NO STUDS
ARE FOUND TO SECURE THROUGH,
NOGGINS MAY BE REQUIRED.
PRIOR TO INSTALLATION
Argent recommends a qualified trade
person fit your vanity. Ensure your
furniture is installed to relevant building
codes and Australian Standards.
Please note, Argent will not be liable
for the cost of installation or removal
of the furniture and the warranty will be
voided if damage occurred during or
after installation.
Fit wall hung basin at required height
to secure stud or frame, ensure level.
Fit plumbing.
(1)
You may find it helpful to remove
any shelves, doors and draws of vanity
and set aside carefully. Hold vanity
(2)
over pipes in correct position. Use
scrap blocks of wood to set at just under
correct height.
4
2
2
1
3
4
1
5
850mm
2
3
C
Ensure doors are adjusted to sit square
as they may have moved during
4
transportation.
MEASURE & MARK
(3)
Find
in wall studs to secure to. If aligned with fixing
brackets, mark bottom and sides as well as the middle
bracket hole. Measure and mark position for drilling,
measure from bottom of vanity to holes in
If stud positioning does not align with fixing brackets,
vanity must be secured through the
studs. If no studs are found to secure through, special
fixings may be required. Use fixings appropriate to your
wall material.
FIT OFF & ADJUST
C
Lift vanity to required height and secure appropriate fixing
mechanism into the wall. Drill securing screws (included
with vanity) to all hanging brackets.
Replace any shelves, doors and draws and adjust to
ensure all square with the installed vanity.
Door Adjustment
Adjustment
3
4
5
850mm
2
Drawer Adjustment
Feel under the drawer for
release catches. Squeeze
catches, lift up and towards
you to release the drawer from
the runners.
(4)
bracket.
(5)
back board to
IMP ORTA NT:
INSPECT THE FURNITURE TO
ENSURE NO DAMAGE HAS
OCCURRED DURING TRANSIT.
IF DAMAGE HAS OCCURRED, OR
VISIBLE DEFECTS EXIST, DO NOT
PROCEED WITH INSTALLATION
AND ADVISE ARGENT
Adjustment
IMMEDIATELY.