Cisco AIR-LAP1310G Montageanleitung - Seite 17

Blättern Sie online oder laden Sie pdf Montageanleitung für Drahtloser Zugangspunkt Cisco AIR-LAP1310G herunter. Cisco AIR-LAP1310G 40 Seiten. Cisco aironet 1300 series lightweight outdoor access point

Seite drucken

1. Mounting the Access Point

Figure 5

Point the antenna as accurately as possible in the direction of the remote antenna. The integrated antenna

Step 7

is correctly positioned when the flat face of the radome faces the remote antenna.

Routing the Cables

This procedure explains how to route the power injector cables from the access point to a grounding

block. The grounding block should be installed at the building entry point.

To route and connect cables, follow these steps:

Unspool two 75-ohm cables the full length from the access point to the grounding block, laying them

Step 1

out straight without kinks. Do not cut the cables until you know the total required length between the

access point and grounding block.

Install F-connectors on the access point end of each cable and connect the cables to the access point. For

Step 2

outdoor locations, the cables should slope downward from the access point connectors so that moisture

runs away from the access point during rainstorms. If necessary, form drip loops near the connectors.

Step 3

Dress the cables along the path from the access point to the grounding block. Secure the cables as you

go using UV-stabilized Ty-Wraps or equivalent fasteners.

78-17634-01

shows the access point mounted on the rooftop mast:

Roof-Mount Assembly

1 5

I S

T H

S I D

U P

Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions

Mounting the Access Point