Cisco AIR-LAP1310G Montageanleitung - Seite 31

Blättern Sie online oder laden Sie pdf Montageanleitung für Drahtloser Zugangspunkt Cisco AIR-LAP1310G herunter. Cisco AIR-LAP1310G 40 Seiten. Cisco aironet 1300 series lightweight outdoor access point

Seite drucken

1. Mounting the Access Point

Mounting the Access Point on a Support

This warning applies to outdoor installations:

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Warning

Statement 1030

To attach the access point to a support, follow these steps:

Mount the housing bracket to the mounting bracket by sliding the hang pins on the housing bracket into

Step 1

the hang pin slots on the mounting bracket. The connectors should face downward (See

Figure 13

Secure the housing bracket to the support bracket with four hex bolts and flat washers.

Step 2

Note

Roughly position the integrated antenna by pointing the flat face of the access point toward the site of

Step 3

the remote access point.

After aligning the antenna, tighten all mounting bolts to 6 to 10 ft-lbs.

Step 4

78-17634-01

Mounting the Access Point to the Support

1 5

I S

T H

S I D

U P

Hex bolt with serrated flange and washer (4 locations)

If you are using the integrated antenna, loosely tighten the U bolts so you can adjust the access

point horizontally for antenna positioning.

Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions

Mounting the Access Point

Figure

13).