Cisco AIR-LAP1310G Montageanleitung - Seite 6

Blättern Sie online oder laden Sie pdf Montageanleitung für Drahtloser Zugangspunkt Cisco AIR-LAP1310G herunter. Cisco AIR-LAP1310G 40 Seiten. Cisco aironet 1300 series lightweight outdoor access point

Seite drucken
Safety Precautions
Typical Access Point Installation Components
The access point is designed to be installed in an indoor or outdoor environment, typically on a wall,
tower, or tall building. A typical installation diagram is shown in
Figure 1
Category 5
Ethernet
cable
Ground wires must comply with Sections 810 and 820 of the National Electrical Code and Section 54 of
Note
the Canadian Electrical Code.
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
To ensure correct installation and grounding, install the access point in compliance with your local and
Caution
national electrical codes: National Fire Protection Association (NFPA) 70, National Electrical Code
(U.S.); Canadian Electrical Code, Part I, CSA 22.1 (Canada); and if local or national electrical codes are
not available, refer to IEC 364, Part 1 through 7 (other countries).
The ground block and grounding wire are not required when both the access point and the antenna are
Note
mounted in a sheltered indoor environment.
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
6
Typical Installation Diagram
Indoor
Power
injector
Dual-coax
cables
Power
module
Building
entrance
external antenna
Outdoor
Grounding
block
Dual-coax
cables
Ground
(see note)
Figure
1.
Integrated
or
BR1310G or
LAP1310G
78-17634-01