DigitaLinx DL-HDE100-H2 Benutzerhandbuch - Seite 8
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Extender DigitaLinx DL-HDE100-H2 herunter. DigitaLinx DL-HDE100-H2 15 Seiten.
Seite drucken
DL-HDE100-H2 Owners Manual
HDBaseT Connection
Connect one end of a Category cable to the DL-HDE100-H2 transmitter labeled HDBT OUT, then connect the
other end of the Category cable to the DL-HDE100-H2 receiver labeled HDBT IN
To ensure proper performance of the
F/UTP cabling at a minimum. Category 5e F/UTP may perform well up to a certain length but may not support power over
HDBaseT reliably longer distances.
For optimized performance use the following Liberty Wire and Cable branded cabling;
Category 6 plenum; 24-4P-P-L6SH
Category 6A plenum; 24-4P-P-L6ASH
Category 6 NON-plenum; 24-4P-L6SH
Category 6A NON -plenum; 24-4P-L6ASH
Connecting RS232 Control
RS232 or serial control signals can be transmitted through the DL-HDE100-H2 using the RS232 connection ports
on he DL-HDE100-H2 transmitter and receiver.
RS232 Wiring
Connect the controller or device RX signal
to TX on the
Connect the controller or device TX signal
to RX on the
8
1
8
TIA/EIA-568B
P n 1
Or n e/Wh te
P n 2
Or n e
P n 3
Green/Wh te
P n 4
Blue
P n 5
Blue/Wh te
P n 6
Green
P n 7
Brown/Wh te
P n 8
Brown
DL-HDE100-H2
When using shielded category cabling ALWAYS...
....use shielded connectors
....properly ground the category cable
DL-HDE100-H2
extender.
DL-HDE100-H2
extender.
Twisted Pair Wiring
Use TIA/EIA-568B wiring for Category 6
connection between send and receive
units.
, it is recommended that you use solid core, shielded Category 6