ACU-RITE 00386S Gebrauchsanweisung - Seite 10
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Wetterstation ACU-RITE 00386S herunter. ACU-RITE 00386S 20 Seiten. Weather center
Seite drucken3-in-1 Sensor Installation Guidelines
INSTALLATION HEIGHT
off the ground, in an open area. Higher is better for wind measurements - the
National Weather Service recommends 33 feet high!
MOUNTING OPTIONS
onto wooden posts or surfaces that are 2"x4" or larger. The sensor can also be
mounted directly to 3/4" steel pipe
(available at hardware stores and
home centers).
LEVEL INSTALLATION
bubble level (not included) to ensure
level installation for accurate wind
measurement.
Top or Side Mount
1. Insert the mounting base into the
hole on the bottom of the sensor.
2. Use one of the screws included
in the hardware bag to fasten
the lower sensor housing to the
mounting base.
3. Fasten mounting base to a post or railing
using 2 screws.
Pipe Mount
1. Insert pipe or similar item all the way into
the hole on the bottom of the sensor. Note:
Mounting base is not used.
2. Use one of the screws included in the
hardware bag to fasten the lower sensor
housing securely to the pipe.
The 3-in-1 sensor is now ready to use.
Clear Data Collected During Installation
When installation is complete, clear erroneous data from the display unit by pressing
the "CLEAR RECORD/RESET" button for each category, on the back of the display
inside the battery compartment.
Basic Setup is Complete
The 3-in-1 sensor will now synchronize with the display unit. It may take a few
minutes for synchronization to complete. If both or one of the units appear to be
functioning improperly, please refer to the troubleshooting section.
Mount the sensor at a minimum height of 5 feet (1.5 meters)
The included mounting bracket is designed to screw directly
Use a
Top Mount
10
Side Mount
Pole Mount
Do not install during
electrical storms.
Do not place pole
or sensor near
electrical lines or
electrical equipment.