DigitaLinx DL-UHDILC Handbuch zur Schnellinstallation - Seite 4
Blättern Sie online oder laden Sie pdf Handbuch zur Schnellinstallation für Schalter DigitaLinx DL-UHDILC herunter. DigitaLinx DL-UHDILC 5 Seiten.
Auch für DigitaLinx DL-UHDILC: Benutzerhandbuch (17 seiten)
Seite druckenDL-UHDILC Quick Guide
• (1) DL-UHDILC
• (1) DC12 0.5A Power Adapter
• (3) Phoenix 3.5mm 3 pin Male Connectors
• (1) RS232 to 3 pin Phoenix Breakout Cable
1. Verify all components included are present before installation.
2. Connect an HDMI source device to the HDMI IN port using an HDMI cable
3. Connect a display device to the HDMI OUT port using an HDMI cable
4. Adjust EDID preset for desired resolution setting
5. Connect either S/PDIF OUT or AUDIO OUT to an audio amplifier or AVR for audio
reinforcement with an RCA or 3.5mm audio .cable
6. Connect RELAY1 / RELAY2 to the relay pins of a relay switch on a projector screen
or window shade with a shielded 2 conductor cable such as the Liberty 22-1P-EZ
cable
• RELAY1 will automatically switch from normally open (NO) to normally closed (NC) when a
video signal is introduced to the system. RELAY2 will automatically switch from normally open
(NO) to normally closed (NC) when a video signal is absent from system after a specified time
that has been determined by the serial upload software
7. Connect the 3 pin phoenix connector of the RS232 breakout cable to the RS232
port on the DL-UHDILC, then connect the DB-9 side of the breakout cable to a
DB9 cable to connect that will connect to the sink device
• NOTE: The RS232 port on the DigitaLinx DL-UHDILC can be configured by connecting a
computer to the RS232 port of the DL-UHDILC and by using the Display Control software which
is located on the DL-UHDILC product page Online at www.libav.com.
8. Apply power to DL-UHDILC
Package Contents
Connectivity Instructions