DigitaLinx IPEX2100 Series Handbuch zur Schnellinstallation - Seite 11

Blättern Sie online oder laden Sie pdf Handbuch zur Schnellinstallation für Schalter DigitaLinx IPEX2100 Series herunter. DigitaLinx IPEX2100 Series 17 Seiten.

Seite drucken

LAN Cabling

For all LAN cabling, the EIA/TIA-568B crimp pattern must be used on Category 5e or greater cable. In areas with

large amounts of electromagnetic (EM) or radio frequency (RF) interference, a shielded variety of Category 5e or

greater cable is recommended with shielded connectors on both ends of the selected cable.

IPEXCB Controller

In addition to the gigabit switch, the IPEXCB is required for the encoders and decoders to communicate with each

other regardless of system layout, such as one to many.

System Control

There are multiple ways to control the system once installation is complete. There is the DigitalinxIP Control

software for iPad and Windows. While not recommended, the IPEXCB can be controlled through a web browser. A

third party controller can communicate directly with the IPEXCB via the LAN (CONTROL) port or via RS232.

Heat and Ventilation

All electronics generate heat, and excessive heat can cause electronic devices to fail prematurely. The IPEX2101,

IPEX2102 and the IPEX2102MV devices are passively cooled and should not be stacked on top of each other or

other devices. Please leave at least 1 ½ inches (approximately 35-40 mm) of open space by the side vents to

provide adequate airflow. Please see www.libav.com for rackmounting options.

The gigabit switch will likely have active cooling. Please follow the manufacturer's installation instructions for

proper mounting in an equipment rack.

Backup Power

It is always a good practice to install a high quality UPS (uninterruptible power supply) with line filtering with

expensive electronics. The UPS can provide "clean" power to all the devices in the equipment rack while also

providing enough time to properly shut down connected devices in the event of an extended power failure.

HDMI CEC

The IPEX2102 and the IPEX2102MV can turn on and turn off connected displays via CEC. This technology has been

a part of the HDMI specification for years. The Digitalinx IP Control software for Windows and iPad can turn on and

off the displays for easy end user control.

Source Content Resolution

Even though the IPEX2100 series devices support 1080i, this resolution may cause artifacts through the encoding

process. Please set the output resolution of devices showing 1080i content to 720p or 1080p.

TIA/EIA-568B

Pin 1

Orange/White

Pin 2

Orange

Pin 3

Green/White

Pin 4

Blue

Pin 5

Blue/White

Pin 6

Green

Pin 7

Brown/White

Pin 8

Brown

IPEX2100 Series Quick Install Guide