Cisco Aironet 2600 Series Handbuch "Erste Schritte - Seite 13

Blättern Sie online oder laden Sie pdf Handbuch "Erste Schritte für Drahtloser Zugangspunkt Cisco Aironet 2600 Series herunter. Cisco Aironet 2600 Series 39 Seiten.
Auch für Cisco Aironet 2600 Series: Handbuch "Erste Schritte (27 seiten), Datenblatt (7 seiten)

Seite drucken

Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use

Step 1

the CLI, web-browser interface, or Cisco WCS procedures as described in the appropriate

Cisco wireless LAN controller guide.

a. Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller

Management and AP-Manager Interface.

b. Configure the switch to which your access point is to attach. See the Cisco Unified Wireless

Network WLAN Controller Guide: Cisco 440x Series WLAN Controllers for additional

information.

c. Set the Cisco wireless LAN controller as the master so that new access points always join with

it.

d. Make sure DHCP is enabled on the network. The access point must receive its IP address

through DHCP.

e. CAPWAP UDP ports must not be blocked in the network.

f. The access point must be able to find the IP address of the controller. This can be

accomplished using DHCP, DNS, or IP subnet broadcast. This guide describes the DHCP

method to convey the controller IP address. For other methods, refer to the product

documentation. See also the

information.

Step 2

Apply power to the access point:

a. The access point is 802.3af (15.4 W) compliant and can be powered by any of the following

802.3af compliant devices:

WS-C3550, WS-C3560, and WS-C3750 switches

–

C1880 switch

–

2600, 2610, 2611, 2621, 2650, and 2651 multiservice platforms

–

2610XM, 2611XM, 2621XM, 2650XM, 2651XM, and 2691 multiservice platforms

–

2811, 2821, and 2851 integrated services routers

–

3620, 3631-telco, 3640, and 3660 multiservice platforms

–

3725 and 3745 multiservice access routers

–

3825 and 3845 integrated services routers

–

The recommended external power supply for the access point is the Cisco AIR-PWR-B

power supply. The access point can also be powered by the following optional external

power sources:

1250 series access point power injector (AIR-PWRINJ4)

–

Any 802.3af compliant power injector

–

"Using DHCP Option 43" section on page 16

for more