Ace FMC-200-HYD-310 Gebrauchsanweisung - Seite 10

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Water Pump Ace FMC-200-HYD-310 herunter. Ace FMC-200-HYD-310 12 Seiten. Hydraulic motor driven centrifugal pumps

Seite drucken

1. Pump Repair Kits

HYDRAULIC MOTOR REPAIR KITS

Ace hydraulic motor repair kits include all O-rings and seals necessary to rebuild the motor. The motor

model number and date code are stamped on the end plate below the ports. The 200 series kit will fit

all motors including those with "L", "N", or "R" designation. The 300 series kit will fit all motors including

those with "L" or "A" designations except 310 motors with G-5 or earlier date codes.

Motor Model

200 Series Motors (202, 203, 204, 206, 210)

300 Series Motors (304, 305, 306, 307, 310)

310 Motor (G-5 or earlier)

MOTOR REPAIR KIT INSTALLATION

NOTE: The seal cartridge comes on an installation bullet with a small diameter for storage and

a larger diameter for installation. The seal lips curve towards the larger diameter when properly

installed on the bullet. The seal should remain on the bullet until installation for best results.

DISASSEMBLY:

1. Remove motor from pump by removing four cap screws.

2. Remove seal retaining ring from drive plate if installed and discard.

3. Remove two 1/4" cap screws (200 series) or four 3/8" cap screws (300 series).

4. Draw or scribe a line on motor casing (end plate, drive plate, housing), note orientation, and

pull apart.

5. Remove idler gear/shaft assembly, drive gear, and drive shaft dowel pin.

Note: Failure to remove dowel pin will result in bushing damage.

6. Press or tap (non-marring hammer) drive shaft/bearing assembly, and seal cartridge out of

drive plate.

7. Remove and discard old "O" rings and seal cartridge. Check shaft for wear or grooving under

seal and replace if damaged.

Repair Kit Part Number

RK-BAC-75-HYD-L

RK-BAC-75-HYD-300-L

RK-BAC-75-HYD-310

Disassembly Step 6

Ace EDP#

41374

41362

41379