Epson W70 Schnelles Einrichten - Seite 2

Blättern Sie online oder laden Sie pdf Schnelles Einrichten für Projektor Epson W70 herunter. Epson W70 4 Seiten.

Seite drucken

Pass the USB power cable through the hook and clamp, depending on

the location of the power port on your streaming device as shown below,

then close the clamp to secure the cable.

Device's power port on the side

Device's power port on the bottom

Replace the rear cover of the projector.

Turn on the projector

Plug in the projector.

Press the

power button on the projector or the projector remote

control. The

power light flashes blue, then stays on.

The default language of the menu system is English. To select another

language, press the

menu button on the projector remote control.

Select Settings and press Enter. Select Language and press Enter. Select

your language and press Enter. Press the

Note: To shut down the projector, press the power

or the remote control, then press the button again to confirm, if necessary.

menu button to exit.

button on the projector

Adjust the image

Move the focus lever on top of the projector left or right to adjust the

image sharpness.

To adjust the image height, press and hold the foot release lever on the

bottom of the projector to extend the front adjustable foot. Release the

lever to lock the foot in the desired position.

Using the remote control

Install the batteries as shown (two AAA batteries).

Turn projector on or off

Enter a selection

Control playback of

connected device

Access projector menus

Turn off audio and

video temporarily

See the online User's Guide for more information on using the remote control.

Troubleshooting

•

If you see a No signal message after turning on the projector, make sure

your streaming device or HDMI cable is properly connected.

•

If you see a blank screen, check the following:

•

Make sure the

power light on the projector is blue and not

flashing.

•

Press the

power button to wake the projector from standby or

sleep mode, if necessary.

Go back to previous

function

Navigate menus

Change color mode

Adjust image shape

(keystone)

Turn volume up or down