11
In OS X 10.4.x, select AL-CX11.
In OS X 10.2.x to 10.3.x, select EPSON USB
and AL-CX11.
Note: If AL-CX11 doesn't appear, make sure it is
turned on and securely connected to
your Macintosh.
12
Click the Add button. You see the
AL-CX11 in the Printer List.
13
Quit the Printer Setup Utility or
Print Center.
You are now ready to print, copy, and scan.
CX11N as a Network Printer
Connect the CX11N
Note: A network cable is not included with the CX11N.
1
Make sure that your printer is turned off.
2
Connect one end of the network cable to the RJ-45 connector on the
CX11N, and the other end to the network.
Caution: You must use a Category 5 shielded twisted-pair cable to
prevent malfunction.
Do not connect or disconnect the network cable while the printer is on.
Do not connect the CX11N and a computer directly. Be sure to use a hub
to connect the CX11N to the network.
3
Turn on the CX11N.
Caution: After turning off the printer, wait until the status lights go off before
turning it back on; otherwise the network interface may not work correctly.
Set the IP Address
Dynamic
If DHCP is running on your network, an IP address is automatically assigned to
the printer once it is connected. Follow these steps to view the IP address:
1
Press the
The Setup light turns on and the LCD screen shows Setup Mode for a
few seconds, then changes to the Setup menu screen.
2
Press the
the
button.
3
Press the
the
button.
4
Press the
the
button.
5
Press the
Note: By default, Network Confi g is set to No. After it is set to Yes,
the next time the Network menu is viewed, the Network Confi g setting
reverts to No.
6
Press the
See "Install and Configure the Client Software (Windows Only)" to install the
software on each computer that will be using the CX11N on the network.
Static
1
Press the
The Setup light turns on and the LCD screen shows Setup Mode for a
few seconds, then changes to the Setup menu screen.
2
Press the
the
button.
3
Press the
the
button.
4
Press the
the
button.
Setup button.
button until Host/IF Settings is selected, then press
button until Network Menu is selected, then press
button until Network Config is selected, then press
button until Yes is selected, then press the
button until the IP Address is selected.
Setup button.
button until Host/IF Settings is selected, then press
button until Network Menu is selected, then press
button until Network Config is selected, then press
button.
Seite drucken