Cisco ASR1006 - ASR 1006 Modular Expansion Base Hardware-Installationshandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Hardware-Installationshandbuch für Drahtloser Zugangspunkt Cisco ASR1006 - ASR 1006 Modular Expansion Base herunter. Cisco ASR1006 - ASR 1006 Modular Expansion Base 47 Seiten. Lightweight access points
Auch für Cisco ASR1006 - ASR 1006 Modular Expansion Base: Handbuch für den Einsatz (40 seiten)
Seite drucken
Figure 3
Cisco ASR 1006 Router Rear Rack-Mounting
1
Rear rack-mount bracket attached to the chassis
Rear rack-mount bracket component
2
Insert and tighten the five screws. After the bracket is secured to the side of the chassis, slide the two remaining
Step 3
components (item 3,
Repeat Step 1 through Step 3 on the other side of the chassis. Use five screws on each side to secure the rear rack-mount
Step 4
brackets to the chassis.
This completes the procedure for attaching rear rack-mount brackets to the chassis. Continue on to
page 6
or
Two-Post Rack Installation, page
Read the following important notices before you begin to install the chassis into an equipment rack:
The Cisco ASR 1006 Router requires a minimum of 6 rack units (10.45 inches or 26.6 cm) of vertical rack space. Measure the
•
proposed rack location before mounting the chassis in the rack .
• Maintain a minimum clearance of 3 inches (7.62 cm) for the front and rear of the chassis for proper chassis cooling. Avoid
placing the chassis in an overly congested rack or directly next to another equipment rack; otherwise, the heated exhaust
air from other equipment can enter the inlet air vents and cause an over-temperature condition inside the router.
• If rack space allows, it is recommended to leave one rack unit (1.75 inch or 4.45 cm) of vertical clearance between the
chassis and any equipment directly above it or below.
Four-Post Rack Installation
This section describes the types of racks used for rack-mounting the chassis.
6
1
0
Figure
3) into the side rack-mount bracket.
8.
1
2
1
0
3
Components that slide into the mounted bracket
Rear rack-mount bracket screw
4
3
4
Four-Post Rack Installation,