Epson Artisan 700 Series Faq - Seite 2

Blättern Sie online oder laden Sie pdf Faq für Alles in einem Drucker Epson Artisan 700 Series herunter. Epson Artisan 700 Series 4 Seiten. Using the control panel for wireless network installation
Auch für Epson Artisan 700 Series: Handbuch zur Netzwerkinstallation (41 seiten), Benutzerhandbuch (11 seiten), Wichtige Informationen zur Einrichtung (3 seiten), Benutzerhandbuch (34 seiten), Benutzerhandbuch (38 seiten), Spezifikationen (2 seiten), Schnellstart-Handbuch (8 seiten), Produkt-Support-Bulletin (5 seiten), Funktion Handbuch (28 seiten)

Identify the Waste Pad Holder The waste pad in a PX700 is

located above the metal plate you can see in the base of the

printer (left).

Remove Retaining Screw & Release Clip/Tab To release

the waste pad holder, you need to remove the screw

(indicated left)... ..then gently push in the retaining tab using a

flat head screwdriver.

Note: Don't push in too far or hard as the tab is fragile and

can easily snap off. The location of the tab, and the hole to

access it, is shown in the picture (indicated left/below)

Normally the waste pad holder will drop down once the

retaining tab has released but if it needs any additional

encouragement, gently prise the holder down, as shown in

the image left. The holder should then drop down as shown in

the second image (left, below)

Release the Waste Tube As you remove the pad holder you

will normally find the tube pulls itself out of the grey plastic

box retainer that holds the open end in position. If not, gently

pull it out yourself. Tip: The correct end of the tube is the end

connected to the waste pads.

The Solo-X Tube Part (quick intro') The Solo-X tube part

consists of two sections A shorter internal section with two

tube connectors A longer external section with an open end,

clamp and green connector to hook it up to the waste tank.

You will need to take the two sections apart, ensuring the

shorter internal piece retains both the tube connectors.

Solo-X Internal tube section As noted above, the internal

tube section has two connectors, one at either end. It is

important to note that one connector is slightly larger than the

other. The larger sized connector will join with the printers

own waste tube The smaller sized connector will join with the

external Solo-X tubing section

(Note: don't join them yet - you'll see why later)

Connect Solo-X Inner Tube Section With Printer Waste

Tube Having identified the correct end to use, join the inner

tube section with the printers own waste tube as shown in the

two images left and below.

2/4