Cisco WAP150 Schnellstart-Handbuch - Seite 9
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Drahtloser Zugangspunkt Cisco WAP150 herunter. Cisco WAP150 13 Seiten. Reboot and reset to factory default settings
Auch für Cisco WAP150: Handbuch (4 seiten)
Seite drucken
- 1. Before You Begin
- 2. Cisco WAP150 Features
- 3. Mounting the Cisco WAP150
- 4. Wall Mounting
- 5. Placement Tips
- 6. Connecting the Cisco WAP150
- 7. Verifying the Hardware Installation
- 8. Getting Started with the Configuration
- 9. Suggested Next Steps
- 10. Troubleshooting
- 11. Rebooting the Cisco WAP150 or Resetting to Factory Defaults
- 12. Where to Go from here
Request timed out.
Possible Cause of Installation Failure
No Power
Power up the switch and your computer if they are turned off.
Make sure that your PoE switch is powered on and the lights indicate that
you have a link. See
Verifying the Hardware
Installation.
Verify that the devices on your network are not plugged into a switchable
outlet.
Bad Ethernet Connection
Check the state of the indicator lights. See
Verifying the Hardware
Installation.
Check the Ethernet cable to ensure that it is firmly connected to your
devices. Devices connected by the Ethernet cable can include the WAP
devices, and routers, any switches, and your computer.
Verify that the connected switch has auto-negotiation enabled. The Cisco
WAP150 and the switch need the same negotiation parameters set.
Bad Image
After a new firmware installation, if the POWER light is solid red, which
indicates that the device fails to boot with both firmware images, contact
system support; see
Where to Go From
Here.
Incorrect IP Address
The most likely cause of connectivity failure is an incorrect IP address. The
Web browser may be pointing to the wrong IP address, or your computer
may be configured with an IP address that is not in the same subnet as the
Cisco WAP150.
Because the factory default IP address configuration is DHCP, make sure
that your DHCP server is running and can be reached. You may need to
disconnect and reconnect the devices for them to discover their new IP
addresses from the DHCP server. You can then query the DHCP server for
the new IP address. See
Step 2
of
Getting Started with the
Configuration
for more information on how to find the DHCP address.
If the Cisco WAP150 does not receive a DHCP response (there is no DHCP
server on your network) after 60 seconds, the Cisco WAP150 will fallback
to the following default static IP address: 192.168.1.245 and a default mask
of 255.255.255.0. To reach that IP address, be sure that your computer is
on the 192.168.1.xxx network.
Cisco WAP150 Quick Start Guide
9