Cisco WAP571E Schnellstart-Handbuch - Seite 9
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Drahtloser Zugangspunkt Cisco WAP571E herunter. Cisco WAP571E 17 Seiten. Manually connect access points to the network via power over ethernet (poe)
Auch für Cisco WAP571E: Handbuch (4 seiten), Schnellstart-Handbuch (6 seiten)
Seite drucken
Connecting the Cisco WAP571E Wireless-
4
AC/N Premium Dual Radio Outdoor Access
Point
You can perform the initial configuration using either a wired or wireless
connection. The default configuration of the WAP 571 has the Wi-Fi radio
turned on.
To connect the WAP 571E to the wired network:
Connect the Ethernet cable to the Ethernet port of a PoE switch.
S
1
TEP
Connect the other end of the network Ethernet cable to the
S
2
TEP
Ethernet port (PoE) of the wireless access point.
WAP571E bundles the two Ethernet ports to be link aggregation
N
OTE
mode. If the two Ethernet ports have been connected at the same time,
the link partner must also support link aggregation.
This wireless default configuration will not allow traffic between WiFi and
Ethernet; users will need to go through the setup wizard to resume the
traffic between WiFi and Ethernet.
To connect the WAP 571E to the network wirelessly:
Use wireless clients to locate the WAP571E's SSID (CiscoSB-
S
1
TEP
Setup).
Use the 'cisco123' passkey to access the access point.
S
2
TEP
The system provides a one-time-only access to configure the
N
OTE
access point using a wireless connection.
After installation, all lights should be active. Refer to
Hardware Installation
571E.
Cisco WAP571E Wireless Access Point
for details about the different lights on the WAP
Verifying the
8