Sony 75X95K Referenzhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Referenzhandbuch für TV Sony 75X95K herunter. Sony 75X95K 41 Seiten.

Seite drucken

XR-85X95K

XR-75X95K / 65X95K

• Ensure your TV has adequate ventilation, refer to the

safety documentation.

• For best picture quality, do not expose the screen to direct

illumination or sunlight.

• Avoid installing the TV in a room with reflective wall and

floor materials.

• Avoid moving the TV from a cold area to a warm area.

Sudden room temperature changes may cause moisture

condensation. This may cause the TV to show poor

picture and/or poor color. Should this occur, allow

moisture to evaporate completely before powering the TV

on.

Securing the TV

Sony strongly recommends taking

measures to prevent the TV from

toppling over.

Unsecured TVs may topple and result

in property damage, serious bodily

injury or even death.

Preventing the TV from Toppling

• Secure the TV to a wall and/or Stand.

• Do not allow children to play or climb on furniture and TV

sets.

• Avoid placing or hanging items on the TV.

• Never install the TV on:

— slippery, unstable and/or uneven surfaces.

— furniture that can easily be used as steps, such as a

chest of drawers.

• Install the TV where it cannot be pulled, pushed, or

knocked over.

• Install the TV so that the TV's Table-Top Stand does not

protrude out from the Stand (not supplied). If the

Table-Top Stand protrudes out from the Stand, it may

cause TV set to topple over, fall down, and cause personal

injury or damage to the TV.

• Route all AC power cords and connecting cables so that

they are not accessible to curious children.

Recommended Measures to Secure the

Consider the following measures when securing your TV to

a Stand (not supplied).

Secure the Stand for the TV.

Make sure the Stand can adequately support the weight

of the TV. Use two angle braces (not supplied) to secure

the Stand. For each angle brace use the appropriate

hardware to:

• Attach one side of the angle brace to the wall stud.

• Attach the other side to the Stand.

Secure the TV to the Stand.

Use the optional hardware listed as follows (not

supplied):

• M6 machine screws (screwed into the TV's rear cover).

• A screw or similar (attach it to the Stand).

• Rope or chain (strong enough to support the weight of

the TV). Make sure that there is no excess slack in the

rope or chain.

Screw

(not supplied)

Angle brace

(not supplied)

Stand

Screw hole on the

rear cover

M6 machine screw

(not supplied)

Rope or chain

(not supplied)

1.5 N·m

{15 kgf·cm}