Sony BRAVIA KD-43X85K Referenzhandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Referenzhandbuch für TV Sony BRAVIA KD-43X85K herunter. Sony BRAVIA KD-43X85K 44 Seiten.
Auch für Sony BRAVIA KD-43X85K: Referenzhandbuch (16 seiten), Referenzhandbuch (2 seiten), Setup-Handbuch (2 seiten), Setup-Handbuch (2 seiten)
Seite drucken
KD-85X85K / 85X80K / 85X80CK
KD-75X85K / 65X85K / 55X85K / 50X85K /
43X85K
• Ensure your TV has adequate ventilation, refer to the
safety documentation.
• For best picture quality, do not expose the screen to direct
illumination or sunlight.
• Avoid installing the TV in a room with reflective wall and
floor materials.
• Avoid moving the TV from a cold area to a warm area.
Sudden room temperature changes may cause moisture
condensation. This may cause the TV to show poor
picture and/or poor color. Should this occur, allow
moisture to evaporate completely before powering the TV
on.
Securing the TV
Sony strongly recommends taking
measures to prevent the TV from
toppling over.
Unsecured TVs may topple and result
in property damage, serious bodily
injury or even death.
Preventing the TV from Toppling
• Secure the TV to a wall and/or Stand.
• Do not allow children to play or climb on furniture and TV
sets.
• Avoid placing or hanging items on the TV.
• Never install the TV on:
— slippery, unstable and/or uneven surfaces.
— furniture that can easily be used as steps, such as a
chest of drawers.
• Install the TV where it cannot be pulled, pushed, or
knocked over.
• Install the TV so that the TV's Table-Top Stand does not
protrude out from the Stand (not supplied). If the
Table-Top Stand protrudes out from the Stand, it may
cause TV set to topple over, fall down, and cause personal
injury or damage to the TV.
• Route all AC power cords and connecting cables so that
they are not accessible to curious children.
4
US
Recommended Measures to Secure the
TV
Consider the following measures when securing your TV to
a Stand (not supplied).
1
Secure the Stand for the TV.
Make sure the Stand can adequately support the weight
of the TV. Use two angle braces (not supplied) to secure
the Stand. For each angle brace use the appropriate
hardware to:
• Attach one side of the angle brace to the wall stud.
• Attach the other side to the Stand.
2
Secure the TV to the Stand.
Use the optional hardware listed as follows (not
supplied):
• M6 machine screws (screwed into the TV's rear cover).
• A screw or similar (attach it to the Stand).
• Rope or chain (strong enough to support the weight of
the TV). Make sure that there is no excess slack in the
rope or chain.
1
2
4
Screw
(not supplied)
The length of the M6 machine screw differs depending
on the rope or chain diameter. Please refer to below
illustration.
10 mm - 12 mm
VS
Angle brace
(not supplied)
Stand
Screw hole on the rear cover
VS
(supplied)
M6 machine screw
(not supplied)
Rope or chain
(not supplied)
1.5 N·m
{15 kgf·cm}
Screw (M6)
Rope or chain