DigiTech Death Metal Distortion Handbuch - Seite 10

Blättern Sie online oder laden Sie pdf Handbuch für Musik-Pedal DigiTech Death Metal Distortion herunter. DigiTech Death Metal Distortion 12 Seiten.

Battery Replacement

1. Using the tip of a 1/4" guitar cable, push one of the release pins in on

either side of the pedal, and remove the pedal from the pedal chassis.

2. Remove the battery from the battery compartment and disconnect

the battery cable.

3. Connect a new battery to the battery cable and put it back in the

battery compartment. Make sure the battery cable does not interfere

with the spring or pedal switch arm.

4. Place one hole of the pedal over its corresponding pin.

5. Push the opposite pin in and lower the other side of the pedal into

place over the depressed pin. Release the pin. When the pedal is

properly fastened, both released pins are flush with the outer side of

the pedal.