Epson L3160 Hier beginnen - Seite 2

Blättern Sie online oder laden Sie pdf Hier beginnen für Alles in einem Drucker Epson L3160 herunter. Epson L3160 4 Seiten.

Seite drucken

Close the black ink tank cap.

Repeat the previous steps for the other colors.

Caution:

After setup, periodically inspect the ink levels to ensure

they do not fall below the

level is lower than the line could damage the product. See the

online User's Guide for refilling instructions.

Close the ink tank cover.

Connect the power cord to the back of the product and to

an electrical outlet.

Caution:

Do not connect to your computer yet.

Raise the control panel, then press the

turn on the product. The

Select your language.

Note:

You can change this setting later using the product's

control panel. For more information, see the online User's Guide.

When instructed to see the Start Here sheet, press and

hold the

help button for 5 seconds.

lower lines. Prolonged use when any

power button to

power light flashes.

Press the

start button to start ink charging.

Note:

Ink charging takes about 10 minutes. When the

light stops flashing, ink charging is complete. Once initial setup

of the printer is complete, you can top off the ink tanks with any

remaining ink. See the online User's Guide for instructions.

Caution:

Do not unplug or turn off the product, or open the

inner cover while the product is charging or you'll waste ink.

Press the OK button to proceed with initial setup.

Follow the on-screen instructions to adjust the print

quality of your product.

Note:

• You need to load paper before you can adjust the print quality.

See "Load paper" below for details.

• Select Adjust Later if you want to adjust the print quality later.

For more information, see the online User's Guide.

Load paper

See the online User's Guide for information about loading

capacity, available paper types and sizes, and loading

envelopes.

Make sure the product is not charging ink. Open the

feeder guard then raise the paper support and tilt it

backwards slightly.

Slide the edge guides all the way out.

Load paper, glossy or printable side up and short edge

first, in the middle of the rear paper feed slot.

Note:

Make sure the paper is under the

guides.

power

mark inside the edge