Cisco Profile Series Schnellstart-Handbuch

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Konferenz-System Cisco Profile Series herunter. Cisco Profile Series 4 Seiten. Jbod on the 12g sas modular raid controller
Auch für Cisco Profile Series: Handbuch "Erste Schritte (41 seiten), Benutzerhandbuch (44 seiten), Benutzerhandbuch (7 seiten), Handbuch "Erste Schritte (35 seiten), Kurzreferenz-Handbuch (2 seiten), Installationshandbuch (44 seiten), Konfigurationshandbuch (13 seiten), Installationsblatt (2 seiten), Installationshandbuch (2 seiten), Schnellstart-Handbuch (4 seiten), Handbuch zur Installation (16 seiten), Handbuch "Erste Schritte (32 seiten), Handbuch (16 seiten), Handbuch "Erste Schritte (42 seiten), Handbuch "Erste Schritte (46 seiten)

Contents

Introduction

Prerequisites

Components Used

Configure

Introduction

This guide is inteded to show you how to configure 'Just a bunch of disks' (JBOD) on the Cisco

12G SAS Modular RAID Controller in a C-Series server.

Caveats:

* JBOD disks are not able to take advantage of any hardware caching on the RAID controller.

http://www.redbooks.ibm.com/redpapers/pdfs/redp5234.pdf

JBOD)

* If caching is required on these disks, then you can put them into a RAID 0 array (striping) and

present this to the OS. Recall that RAID0 has no parity, so please note that the more disks added

to a RAID 0, the larger your failure domain, or the greater the chance of data loss across all disks

due to a single disk failure. This is the nature of RAID 0. Good performance, intolerant of even a

single disk failure. This is acceptable for some applications and use cases however.

Prerequisites

C-Series Server

Cisco 12G SAS Modular Raid Controller

1 or more HDD

Access to CIMC / KVM

Components Used

Cisco C240-M4 running 2.0(6d) CIMC

Cisco 12G SAS Modular Raid Controller running 4.250.00-3632

Configure

As a safety precaution, if you have a pre-existing RAID configuration, please back up the data on

that Virtual Disk (VD) prior to making these changes.

If you have existing Virtual Disk (VD), RAID 1 for instance, that you wish to preserve, its

configuration should be preserved after enabling JBOD, though a reboot is required to enter the

pre-boot RAID configuration menu (CTRL+R) to enable JBOD.

(general documentation on RAID /