Cisco Quick Set C20 Handbuch "Erste Schritte - Seite 19

Blättern Sie online oder laden Sie pdf Handbuch "Erste Schritte für Konferenz-System Cisco Quick Set C20 herunter. Cisco Quick Set C20 35 Seiten. Tc7.3, english, december 2015
Auch für Cisco Quick Set C20: Handbuch "Erste Schritte (41 seiten), Benutzerhandbuch (44 seiten), Handbuch "Erste Schritte (42 seiten), Kurzreferenz-Handbuch (2 seiten), Kurzreferenz-Handbuch (2 seiten), Benutzerhandbuch (25 seiten), Handbuch zur Fehlersuche (37 seiten), Installationsblatt (2 seiten), Kurzreferenz-Handbuch (2 seiten), Kurzreferenz-Handbuch (2 seiten), Handbuch "Erste Schritte (32 seiten), Benutzerhandbuch (48 seiten), Handbuch "Erste Schritte (42 seiten), Handbuch "Erste Schritte (46 seiten)

Seite drucken
Cisco Quick Set C20 Handbuch
Cisco TelePresence Systems
GettinG started Guide
Table of contents
Introduction
touch controller
Setting date, time and location
When setting up your video conference system, you
should check that the date and time settings are correct.
Among other things this information is used to time stamp
messages transmitted to gatekeepers and other network
elements.
The time is shown in the top right corner of the Touch
controller display.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces
Configuration
Configuration
1. Tap
More > Settings > Administrator settings > Date,
Time &
Location.
2. Tap
24h
or
12h
to select the
Time format
3. Tap dd.mm.yy,
mm.dd.yy
or
yy.mm.dd
format
you prefer.
4. Select the
Time zone
you are in. Step through the list of
available zones by tapping the ‑ or + signs.
5. Select Auto,
Manual
or
Off
to select the
prefer.
1
If you select Manual, also enter the
in the corresponding input field.
If you select Off, also select the correct value for Hour,
Minute, Year, Month, and
Day
section. Tap the plus and minus signs to increase or
decrease a value.
6. Tap
Save
to save the changes, or
saving.
7. Tap
Exit
to return to the home menu.
1
NTP mode:
Auto:
The time is regularly updated using an NTP server. The
NTP server address is automatically obtained from the
network (DHCP).
Manual: The time is regularly updated using an NTP server. You
must manually enter the NTP server address.
Off:
You must set the time manually. The time will not be
updated automatically.
Appendices
you prefer.
to select the
Date
NTP mode
you
NTP server
address
in the
Date and time
Undo
to leave without
19
www.cisco.com