Argo CLIMIA CMK 4000 WiFi Betriebsanleitung - Seite 8

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Klimagerät Argo CLIMIA CMK 4000 WiFi herunter. Argo CLIMIA CMK 4000 WiFi 20 Seiten. Room air conditioner with remote condenser

Seite drucken
Room air conditioner with remote condenser
09 - REMOTE CONTROL UNIT

HOW TO SET THE CLOCK

1.
Press for a few seconds the Timer button
Press the button
SET
WEEK
S
M
T
W
T
F
S
2.
3.
button
to exit the clock menu.
COOLING / AUTOMATIC MODE
1. Turn on the unit with the ON / OFF
button.
2. Press the button
COOLING symbol
the display.
3. Press the buttons
desired temperature (the temperature
range is between 10 ˚C and 32 ˚C ).
SET
THE DISPLAY SHOWS THE
SELECTED TEMPERATURE
AND THE WORD "SET".
4. Press the button
NOTES
If the fan is set in automatic mode and the unit stops
because setpoint is reached, also the fan will stop.
If the fan is set in one of the six manual speeds, it will
go on operating at the selected speed, even if the unit
stops due to reaching the setpoint.
When the external or internal temperature is too low,
the unit could limit the speed of the compressor or
formation of ice on the internal heat exchanger.
ARROWS
WEEK
S
until the
WEEK
appears on
2
to set the
1
AFTER 5 SECONDS FROM THE
REQUIRED TEMPERATURE
SETTING THE DISPLAY
WILL SHOW THE ROOM
TEMPERATURE AGAIN.
to select the fan speed.
CMK 4000

DEHUMIDIFYING MODE (DRY)

1. Turn on the unit with the ON / OFF button
2. Press the button
appears on the display
3. Press the buttons
(the temperature range is between 10 ˚C and 32 ˚C ).
SET
THE DISPLAY SHOWS THE
M
T
W
T
F
S
SELECTED TEMPERATURE
AND THE WORD "SET".
NOTES
• Use DRY operation when you want to reduce the
humidity in the room.
• Once the room temperature reaches the set level, the
• During DRY operation, the fan speed is automatically
set (Remote control lamp
• Dry operation is not possible if the indoor temperature
is less than 10 ˚C.
AUTO
SET

FAN ONLY MODE

S
M
T
W
T
F
S
If you want to make air circulate without any temperature
3
control, press the button
4
appears on the display

ADJUSTING THE FAN SPEED

AUTOMATIC
Set with the button
AUTO
. The unit automatically controls the fan speed.
When the air conditioner starts operating, the fan speed
varies according to the thermal load of the room .
NOTE
In FAN ONLY mode, the AUTOMATIC speed corresponds
to the high speed H.
MANUALE
If you want to manually adjust the fan speed just set the
button
as desired:
AUTO
VH
L Low
ML Medium-low
M Medium
until the DEHUMIDIFYING symbol
.
to set the desired temperature
AFTER 5 SECONDS FROM THE
REQUIRED TEMPERATURE
SETTING THE DISPLAY
WILL SHOW THE ROOM
TEMPERATURE AGAIN.
is ON) to maximize
AUTO
until the FAN symbol
.
the "AUTO" position
LM
LM
H
MH
MH Medium-high
H High
VH Very high
7