Cisco TelePresence MX700 Handbuch - Seite 38

Blättern Sie online oder laden Sie pdf Handbuch für Konferenz-System Cisco TelePresence MX700 herunter. Cisco TelePresence MX700 45 Seiten. Single camera on a free standing floor stand or a floor stand secured to the wall
Auch für Cisco TelePresence MX700: Installationshandbuch (32 seiten), Schnellstart-Handbuch (12 seiten), Installationshandbuch (28 seiten), Installationshandbuch (29 seiten), Installationshandbuch (32 seiten), Kurzreferenz-Handbuch (2 seiten), Handbuch (45 seiten), Installationshandbuch (29 seiten), Kurzreferenz-Handbuch (2 seiten), Kurzreferenz-Handbuch (2 seiten), Handbuch "Erste Schritte (46 seiten)

Seite drucken
Cisco TelePresence MX700 Handbuch
Tips and tricks
Table of contents
Introduction
Re-register to feedback from the video system when either
the video system or the control system restarts
Create a user interface
When either the video system or the control system restarts, the control system
must re-register to the events that the video system sends when someone uses
the Touch 10 in-room controls or pushes a new in-room control panel to the
API for in-room control
Touch 10.
Widgets
For terminal output mode:
xfeedback register event/UserInterface/Extensions/Widget
Command reference
For XML output mode:
xfeedback register event/UserInterface/Extensions/Event
Troubleshooting
xfeedback register event/UserInterface/Extensions/Widget/
Tips and tricks
Tips and tricks
Consult the
Examples
D15358.01 APRIL 2016
Collaboration Endpoint software
version 8.1
© 2016 Cisco Systems, Inc.
All rights reserved.
LayoutUpdated
API for in-room control
chapter for more details.
Initialize all widgets
It is important that the control system initializes all the widgets on the Touch 10
in-room control panel in the following situations:
• When the control system connects to the video system for the first time.
• When the video system restarts.
• When the control system restarts.
• When a new in-room control panel is exported to the video system (as
response to a LayoutUpdated event).
If this is not done, then the Touch 10 may show incorrect values and not truly
reflect the status of the room.
Use the
command to set the initial values.
SetValue
Always send values back to the video system when
something changes
To avoid unexpected behavior and ambiguities, the control system must
send
commands to the video system when something changes. This
SetValue
applies also when the change is triggered by someone using the controls on
the Touch 10.
For example, it makes no difference if you use a slider on the Touch 10 in-
control panel to dim the light, or a physical dimmer in the room, or another
touch panel. The control system must always send the dimmer value back to
the video system using the
SetValue
38
always
command.