Argo POLIFEMO ZEUS Betriebsanleitung - Seite 6
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Klimagerät Argo POLIFEMO ZEUS herunter. Argo POLIFEMO ZEUS 11 Seiten. Evaporative air cooler
Seite drucken
-
Natural Mode: the unit works by alternating periods at low, medium or high speed according to a pre-defined
program and accordingly the selected fan speed; in this mode the corresponding LED on the control panel is
Below is the operating diagram of the Natural mode according to the fan speed set:
-
Modalità Sleep: the unit works alternating periods at low, medium or high speed according to a pre-defined program
and accordingly the selected fan speed; in this mode, the corresponding LED on the control panel is
High speed and sleeping mode on: The unit operates at high ventilation speed for 30 minutes, then switches to
medium ventilation speed for 30 minutes, then continues to operate at low ventilation speed.
Medium speed and sleeping mode on: The unit operates at medium ventilation speed for 30 minutes, then continues
to operate at low ventilation speed.
Low speed and sleeping mode on: The unit works constantly in low ventilation speed.
The corresponding LEDs will light up according to the operational ventilation speed
TIMER BUTTON
With the unit on, press this button to select the appliance operation interval.
Press the ON / OFF button, the LED "1H" (1 hour) lights up, press this button repeatedly to select the interval: Led_1H
→ Led_2H → Led_1H + 2H → Led_4H → Led_1H + 4H → Led_2H + 4H → Led_1H + 2H + 4H → all off → 1H, up to a
maximum of 7 hours.
When the selected interval is reached, the unit turns off and goes into stand by mode.
COOL / HUMIDIFIER BUTTON
With the unit on, press this button to activate the COOL (cooling) / Humidifier (humidification) function.
The corresponding LED on the control panel lights up. To deactivate the function, press this button again.
DETECTION FUNCTION and RAPID DETECTION OF THE WATER LEVEL IN THE TANK
When the unit is started in cooling mode, it generally takes 50 seconds to detect any lack of water in the tank: at this point an
acoustic signal is emitted and a light alarm indicates the lack of water; the water pump stops and therefore also the cooling
function.
The "quick water level detection function" takes only 8 seconds: after switching on, within 10 seconds, press and hold the
"cooling / humidification" button for 3 seconds; the unit is able to immediately detect the presence of water in the tank. If
there is not enough water, it signals the lack of water with a 5-second beep.
V 01/21
17