Documentation Updates
Updates to the Software Configuration Guide
These are the updates to the software configuration guide:
•
•
Updates to the System Message Guide
These are the updates to the system message guide:
Error Message VQPCLIENT-2-TOOMANY: Interface [chars] shutdown by active host limit.
Error Message VQPCLIENT-3-VLANNAME: Invalid VLAN [chars] in response.
Error Message WCCP-5-CACHEFOUND: Web Cache [IP_address] acquired.
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(44)SE
18
This information in the "Enabling BPDU Guard" section of the "Configuring Optional
Spanning-Tree Features" chapter in the software configuration guide is incorrect:
When you globally enable BPDU guard on ports that are Port Fast-enabled (the ports are in a Port
Fast-operational state), spanning tree shuts down Port Fast-enabled ports that receive BPDUs.
This is the correct information:
When you globally enable BPDU guard on ports that are Port Fast-enabled (the ports are in a Port
Fast-operational state), spanning tree continues to run on the ports. They remain up unless they
receive a BPDU.
When routing is enabled on the switch, you can configure complete EIGRP routing. However, the
configuration is not implemented because the software supports only EIGRP stub routing, as
described in the "Configuring IP Unicast Routing" chapter of the software configuration guide.
After you have entered the eigrp stub router configuration command, only the eigrp stub
connected summary command takes effect. Although the CLI help might show the receive-only
and static keywords and you can enter these keywords, the switch always behaves as if the
connected and summary keywords were configured.
The system has shut down the specified interface because too many hosts have requested
Explanation
access to that interface. [chars] is the interface name.
Recommended Action
To enable the interface, remove the excess hosts, and enter the no shutdown
interface configuration command.
Explanation
The VLAN membership policy server (VMPS) has specified a VLAN name that is
unknown to the switch. [chars] is the VLAN name.
Recommended Action
Ensure that the VLAN exists on the switch. Verify the VMPS configuration by
entering the show vmps privileged EXEC command.
Explanation
The switch has acquired the specified web cache. [IP_address] is the web cache IP
address.
No action is required.
Recommended Action
OL-14761-01
Seite drucken