Argo HUGO Benutzerhandbuch - Seite 11

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Heizgerät Argo HUGO herunter. Argo HUGO 13 Seiten. Plug-in personal ceramic fan heater

Power button

Press this button to turn the unit on and off. After turning off the fan heater, the fan continues to function for about 60

seconds for cooling.

Temperature (-) and (+) buttons

Set the temperature (15-32 ° C) by pressing

room temperature is equal to the set temperature, the fan heater goes into stand-by mode, when the room temperature

drops, it will resume operation.

TIMER button

To set the power off timer, press the timer button when the unit is working. Press it repeatedly to set the power off, from 0

to 12 hours. To set the power-on timer, press repeatedly the timer button when the unit is in stand-by mode.

OVERHEATING SAFETY DEVICE AND ANTI-TIPPING DEVICE

In case of overheating the safety cut out protecting the heating element will automatically switch off the appliance.

If this happens:

 switch off the fan heater;

 remove the causes of abnormal operation or overheating (i.e. obstacles in front of air inlet or air outlet grille);

 leave the heater cool down for 15/20 minutes;

 switch on again the fan heater.

This fan heater is equipped with an anti-tipping safety device. If it is turned over, an internal switch automatically switches off

the fan heater. Once it is repositioned in a vertical position, the fan heater will resume its correct functioning. To continue

operation, turn on the unit using the control panel.

ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE.

IMPORTANT: DO NOT SUBMERGE THE CERAMIC FAN HEATER IN WATER

Cleaning the outside surface of the appliance

Turn the switch off and unplug before carrying out any maintenance work or moving the appliance.

Use a soft cloth to remove any dust from the fan heater.

If the fan heater is excessively dirty, use a soft cloth moistened with water and a mild detergent at a temperature lower than

50°C. Let the fan heater dry completely before use.

Do not use corrosive detergents or solvents such as petrol. Do not wash the appliance with water.

substances or other items to clean that may damage the surface.

Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.

STORAGE

If the appliance is not used for prolonged periods, it must be stored together with this manual in its original packaging, in a

cool and dry place.

V 06/18

buttons until the desired temperature is reached. When the

MAINTENANCE AND STORAGE

Do not use oils, chemical