Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Hinweis zur Installation - Seite 5

Blättern Sie online oder laden Sie pdf Hinweis zur Installation für Netzwerk-Hardware Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion herunter. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 24 Seiten. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Auch für Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Hinweis zur Installation (14 seiten), Lösungshandbuch (17 seiten), Hinweis zur Installation (46 seiten), Weißbuch (19 seiten), Beschreibung (1 seiten), Produkt-Bulletin (6 seiten), Hinweis (4 seiten), Datenblatt (9 seiten), Datenblatt (18 seiten), Weißbuch (18 seiten), Konfigurationshandbuch (8 seiten), Hinweis zur Installation (28 seiten), Handbuch zur Fehlersuche (11 seiten), Hinweis zur Installation (18 seiten), Benutzerhandbuch (17 seiten), Handbuch (19 seiten), Hinweis zur Installation (36 seiten)

Front Panel Description

This section describes the physical attributes of the Content Switching Module.

Figure 1

Status

LED

The RJ-45 connector is covered by a removable plate.

Note

Status LED

When the CSM powers up, it initializes various hardware components and communicates with the

supervisor engine. The Status LED indicates the supervisor engine operations and the initialization

results. During the normal initialization sequence, the status LED changes from off to red, orange, and

green.

Note

For more information on the supervisor engine LEDs, refer to the Catalyst 6500 Series Switch Module

Installation Guide.

Table 1

Color

Off

Red

78-15751-01

shows the CSM front panel.

Content Switching Module Front Panel

RJ-45 (Test)

connector

describes the Status LED operation.

Content Switching Module Status LED

Description

The module is waiting for the supervisor engine to provide power.

•

The module is not online.

•

The module is not receiving power, which could be caused by the following:

•

Power is not available to the CSM.

–

Module temperature is over the limit

–

•

The module is released from reset by the supervisor engine and is booting.

•

If the boot code fails to run, the LED stays red after power up.

Catalyst 6500 Series Switch Content Switching Module Installation Note

Front Panel Description

CSG