Cisco 7513 Series Anleitung zum Ersetzen Handbuch - Seite 12

Blättern Sie online oder laden Sie pdf Anleitung zum Ersetzen Handbuch für Netzwerk-Hardware Cisco 7513 Series herunter. Cisco 7513 Series 26 Seiten. Chassis replacement
Auch für Cisco 7513 Series: Schnellstart-Handbuch (44 seiten), Datenblatt (11 seiten), Handbuch (30 seiten), Pflege von (20 seiten), Anleitung zum Ersetzen Handbuch (19 seiten), Anleitung zum Ersetzen Handbuch (22 seiten)

Seite drucken
Cisco 7513 Series Anleitung zum Ersetzen Handbuch

Removing Power Supplies

Caution
proper flow of cooling air through the chassis.
Step 7
Step 8
Step 9
Figure 7
Caution
Removing Power Supplies
Before you can replace the card cage and backplane assembly, you need to remove power supplies
(and the power supply blank, shown in Figure 10, if one is installed in a system with one power
supply), and then replace them after the new card cage assembly is in place.
To remove a power supply, follow these steps:
Step 1
12 Cisco 7513, Cisco 7513-MX, and Cisco 7576 Card Cage and Backplane Assembly Replacement Instructions
Always install blank processor module fillers in empty processor slots to maintain the
Use a screwdriver to tighten both captive installation screws on each processor module.
Attach network interface cables or other devices to the interface ports. Use the notes you
made in the "Port and Slot Configuration Worksheet" section on page 23.
After you reconnect power and turn it on, check the status of the interfaces as follows:
•
Enter the show interfaces [type] or show controllers [type] command to verify that
the system has acknowledged the interfaces and brought them up.
•
Enter the configure command or the setup command facility to configure any new
interface(s) you might have installed. This does not have to be done immediately, but
the interfaces will not be available until you configure them.
Handling a Processor Module During Installation
To prevent ESD damage, handle processor modules by the handles and carrier edges only.
Turn off (O) the system power switch on each power supply you plan to remove.