Tools Required for Maintenance Procedures
Interface processor-specific configuration information is included in the companion
Note
Installation and Configuration
7576 router, as well as in the individual configuration notes that shipped with your spare interface
processors.
Tools Required for Maintenance Procedures
You need the following tools to replace any one of the Cisco 7513, Cisco 7513-MX, and Cisco 7576
internal spares:
•
•
•
Maintenance Procedures for the Cisco 7513, Cisco 7513-MX, and
Cisco 7576
To replace internal spares, all of which are inside the noninterface processor end of the router, you must
remove the chassis cover panel and expose the chassis interior. The Cisco 7513, Cisco 7513-MX, and
Cisco 7576 are housed in the same chassis and use the same power supplies. If a procedure is specific to
one model or the other, it is noted within that procedure.
If the power is not shut down before removing chassis cover panels, high current can become a
Warning
hazard. When the power harness cover is removed, the high current present in the wiring and on the
backplane also becomes a hazard. Removing metal cover panels when the system is operating also
compromises the EMI integrity of the system. Therefore, always turn off the system power before
removing metal cover panels, and remove cover panels only when it is necessary to replace internal
components.
The specific maintenance procedures for your Cisco 7513, Cisco 7513-MX, or Cisco 7576 router are
described in the following sections:
•
•
•
Cisco 7500 Series Installation and Configuration Guide
7-2
3/16-inch flat-blade screwdriver to loosen the captive screws on the processor modules, power
supplies, card cage assembly, and the DC-input terminal connections on DC-input power supplies
Number 1 Phillips screwdriver to loosen captive screws on processor modules that have this type of
screw
Number 2 Phillips screwdriver to remove teh backplane cover screws
Removing Cisco 7513, Cisco 7513-MX, and Cisco 7576 Power Supplies, page 7-3
To install power supplies in the Cisco 7513, Cisco 7513-MX, and Cisco 7576, see the
Note
"Installing Cisco 7513, Cisco 7513-MX, and Cisco 7576 Power Supplies" section on
page
3-27.
Removing and Replacing the Cisco 7513, Cisco 7513-MX, and Cisco 7576 Card Cage Assembly,
page 7-5
Removing and Replacing the Cisco 7513, Cisco 7513-MX, and Cisco 7576 Blower Module, page
7-10
Chapter 7
Maintaining Your Cisco 7513, Cisco 7513-MX, and Cisco 7576 Router
Guide, which shipped with your Cisco 7513, Cisco 7513-MX, or Cisco
Interface Processor
OL-5008-03 B0
Seite drucken