Cisco 7513 Series Anleitung zum Ersetzen Handbuch - Seite 15

Blättern Sie online oder laden Sie pdf Anleitung zum Ersetzen Handbuch für Netzwerk-Hardware Cisco 7513 Series herunter. Cisco 7513 Series 19 Seiten. Chassis replacement
Auch für Cisco 7513 Series: Schnellstart-Handbuch (44 seiten), Anleitung zum Ersetzen Handbuch (26 seiten), Datenblatt (11 seiten), Handbuch (30 seiten), Pflege von (20 seiten), Anleitung zum Ersetzen Handbuch (22 seiten)

If you try to turn on a power supply and the switch resists, the power supply probably is not

Note

fully inserted into the bay. Turn the power switch fully counterclockwise (to O), pull the power

supply out of the bay about two inches, then push the power supply ﬁrmly back into the slot. Do not

slam the supply into the slot—doing so can damage the connectors on the supply and the backplane.

Tighten the captive installation screw before turning on the switch.

Listen for the system blower. You should hear it start operating immediately.

Step 5

On the console terminal, verify that the console displays the system banner and that the

Step 6

system and all interfaces initialize successfully. Following is an example of this display.

(display text omitted)

GS Software (RSP-K), Version 10.3(571)

Compiled Wed 10-May-95 25:12

RSP2 (Risc 4600) processor with 16384K bytes of memory.

(display text omitted)

If the power supplies do not start up, or if the system or any interfaces do not initialize properly, refer

to the Cisco 7513 Hardware Installation and Maintenance publication for additional information

and installation troubleshooting procedures. If necessary, contact a service representative. (See the

following section "Cisco Information Online.")

Cisco 7513 Card Cage and Backplane Assembly Replacement Instructions

Checking the System