Sony CMR-PC2 USB Betriebsanleitung - Seite 15

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Digitalkamera Sony CMR-PC2 USB herunter. Sony CMR-PC2 USB 26 Seiten. Sony operating instructions usb camera cmr-pc2 usb, cmr-pc3 usb, cmr-pc4 usb

Seite drucken

Removing the Mount

Turn the stand's rotation knob counterclockwise to loosen the suction

mount, and then lift one edge of the suction mount to peel it away from

the mounting surface.

Removing the Camera from the Stand

Remove the camera from its stand as shown in the illustration below.

Detaching the Camera

Note

• If you detach your camera while the computer is powered on, be sure to perform the

following procedures. If this is not performed correctly, there is a risk that the

computer may fail to operate correctly.

• When you detach the camera while the computer power is off, step 1 is not required.

However, when the USB cable is disconnected with the computer in the power saving

mode, the system may not recognise the camera if the USB cable is plugged in again.

Close the software used with your camera.

Unplug the USB cable.

Note

• Unplugging by grasping a part of the cable may result in damage.

Be sure to hold the connector section when unplugging.

• When using the camera monitor mount with the CMR-PC2 USB or the CMR-PC3

USB, pull the arm plate open with your fingers and remove the camera from the

camera monitor mount.

Camera

Suction mount

Rotation knob

Stand