Argo WALLNER HC1601 Gebrauchsanweisung - Seite 14

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Aktenvernichter Argo WALLNER HC1601 herunter. Argo WALLNER HC1601 16 Seiten.

problems
No operation
No operation after
long time operation
stop at shredding
excess squeaking
and rubbing noise
Paper jam
mALFUNtION / mAINtENANCE
If any faults should appear, please pass the machine along with the warranty card to the
seller or closest authorised dealer. The machine might be passed futher, thus the user sho-
uld maintain the original and complete packaging. In cases when the machine is passed for
repair in a not original or incomplete package, the risks of futher damages that might arise
in transportation are on the user's side. Thus, in such a case, it is in the user's best interest
to make the best possible replacement packaging.
© ArGO s.A.
EN
checklists
The power plug is properly
inserted to main supply?
sliding top cover is opened but
power light is off?
No operation when insert paper?
checked above, but still no
operation and no power light?
Power lamp is on?
Machine was continuously
shredding for a longer time?
Without oiling to the cutting
system periodically,
- squeaking and rubbing noise at
shredding may appear.
- exceeding the shredding
capacity
- The paper is not fed squarely
into the feed opening.
14
solutions
Fully put the power plug to the
outlet.
check if the basket is out of
stand. Put basket back to stand.
Paper should be inserted to
trigger the sensor at center.
send back to your local service
for repair.
Unplug the machine from
main supply. Allow to cool
down to room temperature
and resuming operation.
Unplug the machine from
main supply. Allow to cool
down to room temperature
and resuming operation.
Perform the cutter oiling
instruction to lubricate the
cutting system.
set switch to „rev" for reverse
running and frees excess
paper. Then set to „Fwd" for
cutting the remainder of paper
left in the cutting system.
If serious jam occurred, send
back to local service for repair.
www.argo.pl