Sony XCL-CG510C Technisches Handbuch - Seite 8

Blättern Sie online oder laden Sie pdf Technisches Handbuch für Digitalkamera Sony XCL-CG510C herunter. Sony XCL-CG510C 48 Seiten. Digital video camera module

Seite drucken

Rear

5
e
(DC power input) connector (12-pin)
You can connect a camera cable CCXC-12P05N etc. to
input the 12 V DC power supply. The pin configuration
of this connector is as follows. You can operate the
camera without using this connector when using a
PoCL-compatible camera module interface board.
For details on the pin arrangement, see the following
table.
Pin No.
Signal
1
Ground
2
DC 12 V
3
Ground
*1
4
GPO1
5
Ground
*1
6
GPO2
*1
Signal output from pin 4, 6, 9 (GPO1/2/3) of DC
power input connector
This setting allows you to select from exposure
signal, strobe control signal, Hi/Low fixed value, etc.
The initial values of GPO1/2/3 are all Hi fixed.
*2
Signal output from pin 7, 10, 11 (GPI3/2/1) of DC
power input connector
Function as GPI input or trigger input. The initial
setting is GPI1 for trigger input and GPI2/3 for GPI
input.
f DIGITAL Interface connector (26-pin mini
conector)
Camera Link Base Configuration:
You can connect a Camera Link cable to this connector
to control a camera module from a host device utilizing
the serial communication protocol while outputting a
video signal from the camera module. If you use a
camera module interface board with support for PoCL,
you can also supply power from this connecter. You can
input the external trigger signal via the DIGITAL
6
26 13
25 12
15 2
14 1
7
Pin No.
Signal
*2
7
GPI3
8
Ground
*1
9
GPI3
*2
10
GPI2
*2
11
GPI1
12
Ground
Interface connector and operate a camera module in the
external trigger mode.
The following table shows the relation between the pin
numbers of the DIGITAL Interface connector and the
input/output signals and the like.
Pin No.
Signal
1
Power supply or
Ground*
2
X0–
3
X1–
4
X2–
5
XCLK–
6
X3–
7
SerTC+
8
SerTFG–
9
CC1–
10
CC2+
11
CC3–
12
CC4+
13
Ground
* About the 1st pin and 26th pin of the DIGITAL
Interface connector
The connection differs depending on the type of
camera module interface board you use.
In the case of PoCL support: Both the 1st pin and 26th
pin are Power supply
In the case of non-PoCL support: Both the 1st pin and
26th pin are Ground
g Status LED (Green)
Indicates the status of the Camera.
For details, refer to "Status LED" (page 31).
8
Pin No.
Signal
14
Ground
15
X0+
16
X1+
17
X2+
18
XCLK+
19
X3+
20
SerTC–
21
SerTFG+
22
CC1+
23
CC2–
24
CC3+
25
CC4–
26
Power supply or
Ground*