1
1
2
1 8 2
m m
5 3 m
m
Claws
Precautions
Mounting the unit in a Japanese
car
• Choose the installation location carefully so that the
unit will not interfere with normal driving operations.
You may not be able to install this unit in some makes of
• Avoid installing the unit in areas subject to dust, dirt,
Japanese cars. In such a case, consult your Sony dealer.
excessive vibration, or high temperatures, such as in
direct sunlight or near heater ducts.
Note
To prevent malfunction, install only with the supplied screws .
• Use only the supplied mounting hardware for a safe
and secure installation.
How to detach and attach the
Mounting angle adjustment
front panel
Adjust the mounting angle to less than 45°.
Before installing the unit, detach the front panel.
Removing the protection collar
-A To detach
and the bracket
Before detaching the front panel, be sure to press .
Press , then slide the front panel to the right, and
Before installing the unit, remove the protection
collar and the bracket from the unit.
gently pull out the left end of the front panel.
1
Remove the protection collar .
-B To attach
Pinch both edges of the protection collar , then
pull it out.
Place the hole of the front panel onto the spindle
2
Remove the bracket .
on the unit, then lightly push the left side in.
Insert both release keys together between
the unit and the bracket
until they click.
Pull down the bracket
Warning if your car's ignition
, then pull up the unit
to separate.
has no ACC position
Frequency select switch
After turning the ignition off, be sure to press
and hold on the unit until the display
The AM (FM) tuning interval is factory-set to the 9 k
disappears.
(50 k) position. If the frequency allocation system of
Otherwise, the display does not turn off and this causes
your country is based on 10 kHz (200 kHz) interval, set
battery drain.
the switch on the bottom of the unit to the 10 k (200 k)
position before making connections.
RESET button
When the installation and connections are completed, be
sure to press the RESET button with a ballpoint pen, etc.,
after detaching the front panel.
Mounting example
Installation in the dashboard
Notes
• Bend these claws outward for a tight fi t, if necessary (-2).
• Make sure that the 4 catches on the protection collar are
properly engaged in the slots of the unit (-3).
2
Face the hook
inwards.
3
Dashboard
•
•
1
2
•
•
A
TOYOTA
max. size
5 × 8 mm
Bracket
Fire wall
A
B
NISSAN
max. size
5 × 8 mm
to dashboard/centre console
max. size
5 × 8 mm
Bracket
Existing parts supplied with your car
B
to dashboard/centre console
Bracket
max. size
5 × 8 mm
Bracket
Existing parts supplied with your car
Seite drucken