Sony LBT-XGV6 Betriebsanleitung - Seite 37

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Stereo System Sony LBT-XGV6 herunter. Sony LBT-XGV6 44 Seiten.

Seite drucken

There is no sound.

• Turn VOLUME clockwise.

• The headphones are connected.

• Insert only the stripped portion of the speaker

cord into the SPEAKER jack. Inserting the vinyl

portion of the speaker cord will obstruct the

speaker connections.

• The protective device on the amplifier has been

activated because of a short circuit.

("PROTECT" and "PUSH POWER" flash

alternately.) Turn off the unit, eliminate the

short-circuit problem and turn on the power

again.

• There is no audio output during timer recording.

There is no microphone sound.

• Turn VOLUME or MIC LEVEL to adjust the

microphone volume.

• Make sure the microphone is connected to the

MIC1 or MIC2 jack correctly.

There is severe hum or noise.

• A TV or VCR is placed too close to the stereo

system. Move the stereo system away from the

TV or VCR.

The sound from the connected source is

distorted.

• If "VIDEO" appears in the display when you

press FUNCTION (or FUNCTION +/– on the

remote) repeatedly, switch the display to "MD"

(see "Notes" in "Listening to audio from a

connected component" on page 35).

The timer does not function.

• Set the clock correctly.

• Set the timer correctly.

DAILY and REC do not appear when you press

the c/CLOCK SET button.

• Set the timer correctly.

• Set the clock.

The remote does not function.

• There is an obstacle between the remote and the

system.

• The remote is not pointing in the direction of the

system's sensor.

• The batteries have run down. Replace the

batteries.

There is acoustic feedback.

• Decrease the volume level.

• Move the microphone away from the speakers or

change the direction of the microphone.

The color irregularity on a TV screen persists.

• Turn off the TV set once, then turn it on after 15

to 30 minutes. If the color irregularity still

persists, place the speakers farther away from the

TV set.

Speakers

"PROTECT" and "PUSH POWER" appear

alternately.

• A strong signal was input. Press ?/1 to turn off

the power, leave the system turned off for a

while, then press ?/1 again to turn on the power.

• Check the speaker cables in case "PROTECT"

and "PUSH POWER" appear alternately again

after you turn the system on.

Sound comes from one channel or unbalanced

left and right volume.

• Check the speaker connection and speaker

placement.

Sound lacks bass.

• Check that the speaker's + and – jacks are

connected correctly.

continued