Sony MEX-BT39UW Datensatz des Eigentümers - Seite 7
Blättern Sie online oder laden Sie pdf Datensatz des Eigentümers für Stereo System Sony MEX-BT39UW herunter. Sony MEX-BT39UW 45 Seiten. Bluetooth audio system
Auch für Sony MEX-BT39UW: Spezifikationsblatt (4 seiten), Installation/Verbindungen (2 seiten), Service-Handbuch (48 seiten)
Seite drucken
Canceling the DEMO mode
You can cancel the demonstration display which
appears during turning off.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until "DEMO"
appears, then press it.
3
Rotate the control dial to select
"DEMO-OFF," then press it.
The setting is complete.
4
Press
(BACK).
The display returns to normal reception/play
mode.
Preparing the card remote
commander
Remove the insulation film.
Tip
For how to replace the battery, see page 33.
Setting the clock
The clock uses a 12-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until "CLOCK-
ADJ" appears, then press it.
The hour indication flashes.
3
Rotate the control dial to set the hour
and minute.
To move the digital indication, press (SEEK)
–/+.
4
After setting the minute, press the
select button.
The setup is complete and the clock starts.
To display the clock, press (DSPL). Press
(DSPL) again to return to the previous display.
Tip
You can set the clock automatically with the RDS
feature (page 16).
Detaching the front panel
You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
Press and hold (SOURCE/OFF).
1
The unit is turned off.
2
Press
, then pull it off towards you.
(SOURCE/OFF)
Notes
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.
• Do not detach the front panel during playback of the
USB device, otherwise USB data may be damaged.
Attaching the front panel
Engage part A of the front panel with part B of
the unit, as illustrated, and push the left side into
position until it clicks.
Note
Do not put anything on the inner surface of the front
panel.
A
B
7