Sony MHC-RG88 Betriebsanleitung - Seite 24

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Stereo System Sony MHC-RG88 herunter. Sony MHC-RG88 28 Seiten.

Seite drucken

Troubleshooting

Problems and remedies

If you run into any problem using this unit, use

the following check list.

First, check that the power cord is connected

firmly and the speakers are connected correctly

and firmly.

Should any problem persist, consult your

nearest Sony dealer.

General

The display starts flashing as soon as you plug

in the power cord even though you haven't

turned on the power.

The demonstration mode started. Press @/1. (see

step 5 on page 7)

The clock/timer setting is canceled.

• The power cord is disconnected or a power

failure occurs. Redo "Setting the clock"

(on page 8). If you have set the timer, redo

"Waking up to music" (on page 20) and

"Timer-recording radio programs" (on page 14).

The radio presetting is canceled.

• The power cord is disconnected or a power

failure occurs for longer than half a day. Redo

"Presetting radio stations" (on page 11).

There is no sound.

• Turn VOLUME clockwise.

• The headphones are connected to the PHONES

jack.

• Insert only the stripped portion of the speaker

cord into the SPEAKER jack. Inserting the vinyl

portion of the speaker cord will obstruct the

speaker connections.

• The protective device on the amplifier has been

activated because of short circuit. ("PROTECT"

and "PUSH POWER" flash alternately.) Turn off

the unit, eliminate the short-circuit problem and

turn on the power again.

• There is no audio output during Timer-

Recording.

There is severe hum or noise.

• A TV or VCR is placed too close to the unit.

Move the unit away from the TV or VCR.

The sound from the component connected to the

MD (VIDEO) jacks is distorted.

• If "VIDEO" appears in the display when you

press MD (VIDEO), switch to "MD" function

(see "Note: Connecting an MD deck/VCR" on

page 22).

"-- --:-- --" appears in the display.

• A power interruption occurred. Set the clock and

timer settings again.

The timer does not function.

• Set the clock correctly.

• You cannot activate the Daily timer and Timer-

recording simultaneously.

"DAILY1 SET", "DAILY2 SET", and "REC SET"

do not appear when you press the CLOCK/

TIMER SET button.

• Set the timer correctly.

• Set the clock.

The remote does not function.

• There is an obstacle between the remote and the

system.

• The remote is not pointing in the direction of the

unit's sensor.

• The batteries have run down. Replace the

batteries.

There is acoustic feedback.

• Decrease the volume level.

• Move the microphone away from the speakers or

change the direction of the microphone.

The color irregularity on a TV screen persists.

• Turn off the TV set once, then turn it on after 15

to 30 minutes. If the color irregularity still

persists, place the speakers farther away from the

TV set.

"PROTECT"and "PUSH POWER" appear

alternately.

• A strong signal is input. Turn off the power,

leave the system turned off for a while, then turn

on the power again. If "PROTECT" and "PUSH

POWER" still appear alternately check the

speaker cords.

MHC-RG88 E2, E51 4-238-410-73 (1)