Sony R-D-S EON MHC-2900 Betriebsanleitung - Seite 28

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Stereo System Sony R-D-S EON MHC-2900 herunter. Sony R-D-S EON MHC-2900 35 Seiten.

Seite drucken

melam (olele

Information

Precautions

Troubleshooting Guide

Maintenance

Specifications

Glossary

index to Parts and Controls

Index

For Your Information

| Ais

Precautions

If you have any questions or problems

concerning your stereo system, please

consult your nearest Sony dealer.

On operating voltage

Before operating the stereo system, check

that the operating voltage of your stereo

system is identical with the voltage of your

local power supply.

220 ~230 V AC,

50/60 Hz

Operating voltage

On safety

* The unit is not disconnected from the AC

power source (mains) as long as it is

connected to the wall outlet, even if the

unit itself has been turned off.

Unplug the system from the wall outlet

(mains) if it is not to be used for an

extended period of time. To disconnect

the cord (mains lead), pull it out by the

plug. Never pull the cord itself.

Should any solid object or liquid fall into

the component, unplug the stereo system

and have the component checked by

qualified personnel before operating it

any further.

¢ AC power cord must be changed only at

the qualified service shop.

On installation

Place the stereo system in a location with

adequate ventilation to prevent heat build-

up in the stereo system.

On condensation in the CD player

component

If the system is brought directly from a cold

to a warm location, or is placed in a very

damp room, moisture may condense on the

lens inside the CD player. Should this

occur, the CD player will not operate.

Remove the CD and leave the system

turned on for about an hour until the

moisture evaporates.

To save a tape permanently

To prevent a tape from being accidentally

recorded over, break off the cassette tab

from side A or B as illustrated. If you later

want to reuse the tape for recording, cover

the broken tab with adliesive tape.

SOT

SO q

RoI)

——e

When you are using a TYPE If (CrO,) or

TYPE IV (METAL) cassette, be careful not

to cover the detector slots which allow the

tape player to automatically detect the type

of tape.

Detector

slots

in case colour irregularity is

observed on nearby TV screen

With the magnetically shielded type of the

speaker system, the speakers can be

installed near a TV set. However, colour

irregularity may still be observed on the TV

screen depending on the type of your TV

set.

if colour irregularity is observed...

Turn off the TV set once, then turn it on

after 15 to 30 minutes.

If colour irregularity is observed

again...

Place the speakers farther away from the

TV set.

eee

Troubleshooting

Guide

If you run into any problem using the

stereo, use the following check list. And

first check the following points:

¢ The power cord is connected firmly.

The speakers are connected correctly and

firmly.

Should any problem persist after you have

made the checks below, consult your

nearest Sony dealer.

Tuner

"TUNED" flashes in the display.

> Adjust the aerial.

"STEREO" flashes in the display.

> Adjust the aerial.

Severe hum or noise.

> Adjust the aerial.

> The signal strength is too weak.

Connect the external aerial.

> Connect the ground wire.

A stereo FM programme cannot be

received in stereo.

—

-> Press STEREO/MONO so that

"STEREO" appears.