Sony SS-XGR600 Betriebsanleitung - Seite 26

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Stereo System Sony SS-XGR600 herunter. Sony SS-XGR600 36 Seiten. Sony component hi-fi stereo system operating instructions lbt-xgr88/xgr66 lbt-xgr600

Seite drucken

Troubleshooting

Problems and remedies

Should you encounter a problem with your

system, do the following:

Make sure the power cord and speaker

cords are correctly and firmly connected.

Find your problem in the troubleshooting

checklist below and take the indicated

corrective action.

If the problem persists after doing all of the

above, consult your nearest Sony dealer.

When the ?/1 indicator flashes

Immediately unplug the power cord and check

the following items.

• Is the voltage selector set to the correct

voltage?

Check the voltage for your region, then make

sure the voltage selector is set correctly.

• Are the + and – speaker cords short-circuited?

• Are you using only the prescribed speakers?

• Is anything blocking the ventilation holes on

the rear of the system?

After checking the above items and fixing any

problems, connect the power cord again and turn

on the system. If the indicator still flashes, or if

the cause of the problem cannot be found even

after checking all the above items, consult your

nearest Sony dealer.

General

The display starts flashing as soon as you

plug in the power cord even though you have

not turned on the system (see step 5 of

"Hooking up the system" (page 6)).

• Press DISPLAY twice while the system is off. The

demonstration disappears.

"– –:– –" appears in the display.

• A power interruption has occurred. Set the clock

(page 7) and timer settings (pages 20 and 21)

again.

The clock setting/radio presetting/timer is

canceled.

• Redo the following:

–"Setting the clock" (page 7)

–"Presetting radio stations" (page 11)

–"Waking up to music" (page 19)

–"Timer recording radio programs" (page 20)

There is no sound.

• Turn VOLUME control clockwise or press

VOL + on the remote.

• Make sure the headphones are not connected.

• Check the speaker connections (page 5).

• There is no audio output when Timer recording

starts.

There is no microphone sound.

• Turn VOLUME or MIC LEVEL to adjust the

microphone volume.

• Make sure the microphone is connected to the

MIC1 or MIC2 jack correctly.

Sound comes from one channel, or

unbalanced left and right volume.

• Place the speakers as symmetrically as possible.

• Connect the supplied speakers.

Sound lacks bass.

• Check that the speaker's + and – jacks are

connected correctly.

There is severe hum or noise.

• Move the system away from the source of noise.

• Connect the system to a different wall outlet.

• Install a noise filter (commercially available) to

the power cord.

The timer cannot be set.

• Set the clock again (page 7).

The timer does not function.

• Check the timer setting and set the correct time

(pages 20 and 21).

• Cancel the Sleep Timer Function (page 19).

The remote does not function.

• Remove the obstacle.

• Move the remote closer to the system.

• Point the remote at the system's sensor.

• Replace the batteries (R6/size AA).

• Locate the system away from the fluorescent light.

There is acoustic feedback.

• Reduce the volume.