Sony ST-JX311 Service-Handbuch - Seite 3
Blättern Sie online oder laden Sie pdf Service-Handbuch für Stereo System Sony ST-JX311 herunter. Sony ST-JX311 16 Seiten. Fm stereo/fm-am tuner
Auch für Sony ST-JX311: Gebrauchsanweisung (17 seiten)
Seite drucken
SECTION
1
GENERAL
1-1.
LOCATION
OF CONTROLS
POWER switch (ST-JX411 only)
SHIFT button
Display window
MEMORY SCAN button
AUTO TUNING button
[6] TUNING control
BAND FM/AM selector
MEMORY button
[9] Numeric buttons
This section is extracted from
instruction
manual.
1-2.
CONNECTION
° Connect the AC power cord last. Make sure power is off.
° Cord plugs and jacks are color coded.
Red plugs and jacks are for right channel (R) and white ones for the left channel (L).
« The cable connectors shouid be fully inserted into the jacks. A loose connection may cause hum and noise.
* Keep speaker cords, connecting cords and power cords away from the AM loop antenna and the tuner's antenna lead-in
to avoid possible noise pickup.
ST-JX311 Model
@ FM wire antenna (supplied)
Speaker system
Right
Left
For better FM reception
Outdoor FM antenna
(75-ohm coaxial cable)
ST-JX311
For better AM reception
Extend a 6 to 15-meter
insulated wire out of doors
ig also necessary to connect the supplied
M loop antenna.
CAUTION
Do not connect any electical home appliances such as an iron, fan, TV or other high wattage equipment to the AC OUTLET.
CAUTION
Do not put anything like another unit to obstruct the ventilation holes on the top of the amplifier.
The level surface installation is required for essential air ventilation to prevent internal! heat built up in the amplifier.
© Speaker cords
You can connect two pairs of speaker systems: system A and
system B.
They can be selected individually or simultaneously with the
selector on the front panel.
Connect the blue and black connectors to the same color
Use this to power an audio component whose power
connector jacks respectively for controlling each unit.
consumption is less than the wattage indicated on the AC
OUTLET.
~~
This outlet is controlled by the power switch on the
"
amplifier.
Push in until it clicks.
To disconnect.
Adding Other Components to Your System
Turntable system
TA-AX3114
=
to a wall outlet
Line outputs
Audio line outputs
. CD player
Note
The supplied flat cords for tape deck are already connected to the TC-W311,
ST-JX411 Model
@ FM wire antenna (supplied)
@ AM loop antenna (supplied)
To attach to a wall
CONTROLS
OUT
ST-JX414
mS
|@|
t
t
Sy
= wp
CONTROLS
to a wall
outlet or an
:
ar
'
a
AC outlet of
For better FM reception
udio connecting
a
cord (supplied)
the ampiifier
Flat remote control
P
Extend a 6 to 15-meter
err
Outdoor FM antenna
insulated wire out of doors.
Amolifier
(75-ohm coaxial cable)
CONTROLS
Oe
It is also necessary to connect the supplied
AM loop antenna.
® Antenna Ground
To prevent hum, connect the ground wire to
ANTENNA ground terminai (,4-). When an outdoor
antenna is installed, be sure to connect the ground
wire for lightning protection.
@ AC OUTLET (U.S.A. model only)
Use this to power an audio component whose
power consumption is less than the wattage
indicated on the AC OUTLET.
This outlet is controlled by the power switch on the
amplifier.
© Fiat remote control cord (supplied)
IN: Connect to the CONTROL S OUT connector of the
Soy amplifier for whole audio system remote
control.
OUT: Connect to the CONTROL S IN connector of
other Sony equipment with the 4-pin flat remote
control cord for whole audio system remote control.
CAUTION
Do not connect any electicai home appliances
such as an iron, fan, TV or other high wattage
equipment to the AC OUTLET.
Note to CATV system indstaller
This reminder is provided to cail the CATV system
installer's attention to Article 820-22 of the NEC that
provides guidelines for proper grounding and, in par-
ticular, specifies that the cable ground shall be
connected to the grounding system of the building,
as Close to the point of cable entry as practical.
Push in until it clicks.
To disconnect.