Sony ZS-X10WHITE Betriebsanleitung

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Stereo System Sony ZS-X10WHITE herunter. Sony ZS-X10WHITE 2 Seiten. Sony operating instructions personal audio system zs-x10

Seite drucken

On operation

Precautions

• If the player is brought directly from a

cold to a warm location, or is placed in a

very damp room, moisture may condense

On safety

on the lenses inside the CD player section.

• As the laser beam used in the CD player

Should this occur, the player will not

section is harmful to the eyes, do not

operate properly. In this case, remove the

attempt to disassemble the casing. Refer

CD and wait about an hour for the

servicing to qualified personnel only.

moisture to evaporate.

• Should any solid object or liquid fall into

the player, unplug the player, and have it

Notes on CDs

checked by qualified personnel before

• Before playing, clean the CD with a

operating it any further.

cleaning cloth. Wipe the CD from the

• Discs with non-standard shapes (e.g.,

center out.

heart, square, star) cannot be played on

this player. Attempting to do so may

damage the player. Do not use such discs.

Cleaning the cabinet

• Clean the cabinet, panel and controls with

a soft cloth slightly moistened with a mild

detergent solution. Do not use any type of

abrasive pad, scouring powder, or solvent,

such as alcohol or benzine.

• Do not use solvents such as benzine,

On power sources

thinner, commercially available cleaners

or anti-static spray intended for vinyl LPs.

• For AC operation,

• Do not expose the CD to direct sunlight or

use the supplied

heat sources such as hot air ducts, nor

AC power

Polarity of

leave it in a car parked in direct sunlight as

adaptor; do not

the plug

there can be a considerable rise in

use any other type.

temperature inside the car.

• The player is not disconnected from the

• Do not stick paper or sticker on the CD,

AC power source (mains) as long as it is

nor scratch the surface of the CD.

connected to the wall outlet, even if the

• After playing, store the CD in its case.

player itself has been turned off.

If there is a scratch, dirt or fingerprints on the

• Unplug the player from the wall outlet

CD, it may cause tracking error.

when it is not to be used for an extended

period of time.

About CD-Rs/CD-RWs

• For battery operation, use six size C (R14)

This player can play CD-Rs/CD-RWs

batteries.

recorded in the CD-DA format*, but

• When the batteries are not to be used,

playback capability may vary depending on

remove them to avoid damage that can be

the quality of the disc and the condition of

caused by battery leakage or corrosion.

the recording device.

• The nameplate indicating operating

* CD-DA is the abbreviation for Compact

voltage, etc. is located at the bottom.

Disc Digital Audio. It is a recording

On placement

standard used for Audio CDs.

• Do not leave the player in a location near

Music discs encoded with copyright

heat sources, or in a place subject to direct

protection technologies

sunlight, excessive dust or mechanical

This product is designed to play back discs

shock.

that conform to the Compact Disc (CD)

• Do not place the player on an inclined or

standard. Recently, various music discs

unstable place.

• Do not place anything within 10 mm of

encoded with copyright protection

technologies are marketed by some record

the side of the cabinet. The ventilation

companies. Please be aware that among

holes must be unobstructed for the player

those discs, there are some that do not

to operate properly and prolong the life of

conform to the CD standard and may not be

its components.

• If the player is left in a car parked in the

playable by this product.

sun, be sure to choose a location in the car

where the player will not be subjected to

If you have any questions or problems

the direct rays of the sun.

concerning your player, please consult your

• Since a strong magnet is used for the

nearest Sony dealer.

speakers, keep personal credit cards using

magnetic coding or spring-wound watches

away from the player to prevent possible

Troubleshooting

damage from the magnet.

Do not immerse in water

General

This product is not meant to be immersed in

The power does not come on.

water or come in continuous contact with

• Connect the AC power adaptor to a wall outlet

water.

securely.

• Before opening or shutting the CD

• Make sure the batteries are inserted correctly.

compartment or battery compartment lid,

• Replace all the batteries with new ones if they

be sure to wipe off water, dust or sand on

are weak.

the outside of the player.

The power is not on, and "bAttErY"

• Water in the headphones jack/DC IN jack

and "Error" are displayed alternately.

may cause rusting. Cover the jacks with

• Make sure the batteries are inserted correctly.

the attached rubber cap when the jacks are

• Replace all the batteries with new ones if they

not used.

are weak.

• If the player is splashed with salt water,

There is no audio.

wipe clean with a damp cloth, then dry

• Adjust the volume.

with a soft dry cloth. Do not wash under

• Unplug the headphones when listening

running water; do not use soap or

through speakers.

detergent; do not dry with an electric hair

Noise is heard.

dryer.

• Someone is using a portable telephone or

• The supplied AC power adaptor is not

other equipment that emits radio waves near

water resistant. To prevent shock hazard,

the player. tMove the portable telephone,

avoid using the player near water during

etc., away from the player.

AC operation.

CD Player

Specifications

The CD does not play or "no dISC" is

displayed even when a CD is in place.

• Place the CD with the label surface up.

• Clean the CD.

AUDIO POWER SPECIFICATIONS

• Take out the CD and leave the CD

POWER OUTPUT AND TOTAL

compartment open for about an hour to dry

HARMONIC DISTORTION

moisture condensation.

With 3.2-ohm loads, both channels driven

• The CD-R/CD-RW was not finalized. Finalize

from 100 - 10 000 Hz; rated 1.7 W per

the CD-R/CD-RW with the recording device.

channel-minimum RMS power, with no

• There is a problem with the quality of the CD-

more than 10 % total harmonic distortion

R/CD-RW, recording device or application

in AC operation.

software.

• The CD-R/CD-RW is blank.

Other specifications

• Replace all the batteries with new ones if they

CD player section

are weak.

System

The sound drops out.

Compact disc digital audio system

• Reduce the volume.

Laser diode properties

• Clean the CD, or replace it if the CD is badly

Material: GaAlAs

damaged.

Wave length: 780 nm

• Place the player in a location free from

Emission duration: Continuous

vibration.

Laser output: Less than 44.6 µW

• Clean the lens with a commercially available

(This output is the value measured at a distance

blower.

of about 200 mm from the objective lens surface

Lens

on the optical pick-up block with 7 mm

aperture.)

Spindle speed

200 r/min (rpm) to 500 r/min (rpm)

(CLV)

Number of channels

Frequency response

20 - 20 000 Hz +0/–1 dB

Wow and flutter

Below measurable limit

• The sound may drop out or noise may be

heard when using poor quality CD-Rs/CD-

RWs or if there is a problem with the

Radio section

recording device or application software.

Frequency range

You cannot open/close the lid of the

FM: 87.5 - 108 MHz

AM: 530 - 1 710 kHz

CD compartment.

Antennas

• Place the player on a level surface and open/

FM: Telescopic antenna

close the lid.

AM: Built-in ferrite bar antenna

Radio

General

Reception is poor.

Speaker

Full range: 8 cm (3

⁄

inches) dia., 3.2 , cone

• Reorient the antenna to improve FM

reception.

type (2)

Passive radiator: 8 cm (3

⁄

inches) dia. (2)

Outputs

Headphones jack (stereo minijack)

For 16 - 64

impedance headphones

Power output

2.3 W + 2.3 W (at 3.2 , 10% harmonic

distortion)

Power requirements

DC IN 9V jack accepts:

Supplied AC power adaptor for use with 120V

• Reorient the player itself to improve AM

AC, 60 Hz

reception.

9 V DC, 6 size C (R14) batteries

Battery life

CD playback

Sony R14P: approx. 2 h

Sony alkaline LR14: approx. 6 h

Radio play

Sony R14P: approx. 12 h

The audio is weak or has poor quality.

Sony alkaline LR14: approx. 40 h

• Replace all the batteries with new ones if they

are weak.

• Move the player away from the TV.

Dimensions

The picture of your TV becomes

Approx. 511

154 244 mm (w/h/d)

(20

⁄

inches) (incl. projecting parts)

unstable.

• If you are listening to an FM program near the

Mass

TV with an indoor antenna, move the player

Approx. 3.4 kg (7 lb. 5 oz) (incl. batteries)

away from the TV.

Supplied accessory

AC power adaptor (1)

After trying the above remedies, if you still have

Design and specifications are subject to change

problems, unplug the AC adaptor and remove all

without notice.

the batteries. After all the indications in the

display disappear, plug the power cord and

insert the batteries again. If the problem persists,

Optional accessories

please consult your nearest Sony dealer.

Sony MDR headphone series

English

WARNING

To prevent fire or shock hazard, do

not expose the player to rain or

moisture.

Personal

Audio

System

This symbol is intended to alert the

Operating Instructions

user to the presence of uninsulated

"dangerous voltage" within the

product's enclosure that may be of

sufficient magnitude to constitute a

risk of electric shock to persons.

This symbol is intended to alert the

user to the presence of important

operating and maintenance

(servicing) instructions in the

literature accompanying the

appliance.

CAUTION

The use of optical instruments with this product

will increase eye hazard.

WARNING

Do not install the appliance in a confined space,

such as a bookcase or built-in cabinet.

ZS-X10

To prevent fire or shock hazard, do not place

objects filled with liquids, such as vases, on the

appliance.

Printed in China

2-581-447-11 (1)

Power Sources

to a wall outlet

to DC IN 9V

Connect the AC power adaptor A or insert six size C (R14) batteries (not supplied) into the

battery compartment B.

Notes

• Replace the batteries when the OPR/BATT indicator dims or when the player stops operating.

Replace all the batteries with new ones.

• To use the player on batteries, disconnect the AC power adaptor from the player.

Information

Owner's Record

The model number is located at the bottom and

For customers in the USA

the serial number is located in the battery

This equipment has been tested and found to

compartment.

comply with the limits for a Class B digital

Record the serial number in the space provided

device, pursuant to Part 15 of the FCC Rules.

below. Refer to them whenever you call upon

These limits are designed to provide reasonable

your Sony dealer regarding this product.

protection against harmful interference in a

Model No. ZS-X10

residential installation. This equipment

Serial No.

generates, uses and can radiate radio frequency

energy and, if not installed and used in

accordance with the instructions, may cause

For customers in the USA

harmful interference to radio communications.

Please register this product on line at

However, there is no guarantee that interference

http://www.sony.com/productregistration.

will not occur in a particular installation. If this

Proper registration will enable us to send you

equipment does cause harmful interference to

periodic mailings about new product,

radio or television reception, which can be

services and other important announcements.

determined by turning the equipment off and on,

Registering your product will also allow us to

the user is encouraged to try to correct the

contact you in the unlikely event that the

interference by one or more of the following

product needs adjustment or modification.

measures:

Thank you.

— Reorient or relocate the receiving antenna.

— Increase the separation between the

equipment and receiver.

— Connect the equipment into an outlet on a

circuit different from that to which the

receiver is connected.

— Consult the dealer or an experienced radio/

TV technician for help.

This device complies with part 15 of the FCC

rules. Operation is subject to the following two

conditions: (1) This device may not cause

harmful interference, and (2) this device must

accept any interference received, including

interference that may cause undesired operation.

You are cautioned that any changes or

modifications not expressly approved in this

manual could void your authority to operate this

equipment.

Printed on 100% recycled paper using

VOC (Volatile Organic Compound)-

free vegetable oil based ink.